AVIANCE HD04207 3 Light Antique Brass Cast Brass Hardwired Outdoor Instruction Manual

AVIANCE HD04207 3 Light Antique Brass Cast Brass Hardwired Outdoor

Product Information

Specifications:

• Model: HD04207
• Manufacturer: AVIANCE
• Power Source: Electric
• Material: Metal
• Max Wattage: Refer to fixture’s specifications

Product Usage Instructions

Assembling the Fixture:

1. Shut off the power at the circuit breaker and remove the old fixture.
2. Unpack the new fixture and lay out all parts on a clear area.
3. Place the candle sleeve over the lamp holder.
4. Install light bulbs (not included) according to the fixture’s specifications. Do not exceed the maximum wattage rating.
5. Attach the pipe thread into the shade of the lamp body, aligning the box top center screw hole with the pipe thread.
6. Attach the cove to the lamp body and lock it securely with the loop.
7. Attach the lamp body assembly onto the post (not included) and secure it with screws.

Connecting the Wires:

1. Connect fixture wires: black to black house wire (hot), wh to white house wire (neutral).
2. If there are ground wires, connect fixture’s ground w appropriately.
3. Tuck the wire connections neatly into the post.

FAQ
Q: What should I do if I exceed the maximum wattage rating?
A: It is crucial not to exceed the maximum wattage rating specified for the fixture as it can lead to overheating and potential hazards. Please use bulbs within the recommended wattage range.

ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product.
HD04207

• WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
• ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR

ASSEMBLING THE FIXTURE

1. Shut off the power at the circuit breaker and remove old fixture, including the single bar.

2. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.

3.  Put the candle sleeve(G) over the lamp holder.

4. Install the light bulbs (No Included) in accordance with the fixture’s specifications
   NOTE: DO NOT EXCEED THE MAXIMUM
   WATTAGE RATING!

5. Attach the pipe thread(C) into the shade of the lamp body(D), aligning the box top center screw hole with the pipe thread, by turning it clockwise until tight. Attach the cove (B) to the lamp  body(D), then lock it securely with the loop(A).

6. Attach the assembly lamp body onto the post (F, no included) and lock it securely with the screws (E).

CONNECTING THE WIRES

1. Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If   your outlet box has a ground wires (green or bare copper) connect fixture’s ground wire to it. Otherwise attach the bare copper fixture wire to the green ground screw on the mounting plate.
2. Tuck the wire connections neatly into the post.

Your installation is complete. Restore power to the junction box and test the fixture. Thank you for choosing AVIANCE! For parts or assembly assistance, contact customer service at info@aviancelighting.net

Thank you for purchasing an AVIANCE product.
Need assistance with parts or assembly? Please email customer service at:info@aviancelighting.net
©COPYRIGHT ALL RIGHTS RESERVED. AVIANCE LIGHTING,INC.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>