wallbox EM 330 Power Boost Meter Installation Guide
- June 6, 2024
- wallbox
Table of Contents
Wallbox EM 330 Power Boost Meter Installation Guide
Purpose and Scope of the Document
The purpose of this document is to outline the instructions for installation
of energy meters compatible with the Power Boost and Eco-Smart
functionalities.
For instructions to install an MID meter, refer to the relevant
Installation Guide.
Important Notes
- After the installation, connect the energy meter before closing your charger. In case the charger had already been installed, open it to connect the energy meter.
- Only energy meters delivered by Wallbox are compatible.
- The installation must be performed only by suitably qualified personnel, according to local regulations.
- Make sure to update your charger with the latest software version before installing the meter.
- Ensure the charger is powered off before connecting the meter.
- For more information, refer to your charger’s Installation Guide on Wallbox Academy.
Materials and Tools
Inside the Box
Devices
Tools
Compatibility Table
Placement
-
Place the energy meter after the mains supply in the fuse box.
-
For all the meters, follow the corresponding manual included in the box.
Note: For the EM340 and the EM112 meters, only the PF.B versions are compatible with the Eco-Smart functionality.
For the Power Boost functionality, both the PF.A and PF.B versions of EM340 and EM112 meters are compatible.
Refer the Eco-Smart configuration article to know more.
SPM1-100-AC*
Note: Ensure to insert the cable through the clamp in the correct direction as shown.
- Used for 1-Phase installation. Up to 100A.
- Clip the power meter to the mains power cable.
- Neutral cable must not be drawn through the clamp.
*Not compatible with the Eco-Smart functionality.
Pro MOD2 / Pro 380 MOD / N1 CT
A. 1-Phase < 100A
B. 3-Phase < 65A
C. 1 – Phase < 80A
Pulsar Plus
Commander 2
Copper SB
Configuration
Power Boost
Follow these steps to configure the Power Boost functionality.
Eco-Smart
Follow these steps to configure the Eco- Smart functionality.