TECNO KJ7s Smart Phone User Manual

June 25, 2024
TECNO

KJ7s
User Manual

Exploded diagram specification

TECNO KJ7s Smart Phone - diagram

1 TP SP FILM 2 TP+LCM
3 MIDFRAME 4 VOL SIDEKEY
5 POWER SIDEKEY 6 FCAM HOLDER
7 COAXIAL CABLE 1 8 COAXIAL CABLE 2
9 MAIN BOARD 10 32M CAMERA
11 RECEIVER 12 108M CAMERA
13 8M CAMERA 14 UP FRAME
15 TP HEAT 16 MAIN CAM COPPER
17 SCREW 18 MAIN PCB HEAT
19 32M CAM COPPER 20 SIDEKEY FRAME
21 UP FRAME HEAT FILM 22 BATTERY COVER
23 DECO 2 24 DECO 1
25 CAM GLASS 26 MAIN FPC
27 SIM HOLDER 28 SUB BOARD
29 ANT SUB 30 SIDEKEY FPC
31 FINGER PRINT 32 MOTOR
33 SPK FRAME 34 GRAPHITE PLATES
35 SIM CONNECTOR 36 LCM RUBBER
37 USB RUBBER 38 MAIN PCB COPPER
39 2M FPC 40 2M CAMERA
41 BACK LENS

Know your phone

TECNO KJ7s Smart Phone - phone

  1. Front camera
  2. Volume + button
  3. Volume – button
  4. Power button
  5. NFC

SIM card installation

  1. Power off your phone.
  2. Refer to the following picture for SIM card installation.

Charging the phone

You can charge your phone with a charger or by connecting it to a computer using a USB cable (comes with the phone).
Use only TECNO chargers and cables. Other chargers or cables may damage the phone and invalidate its warranty.TECNO KJ7s Smart Phone -
Charging

FCC Caution

  1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
    (1) This device may not cause harmful interference.
    (2) This device must accept any interference received, including interference that may cause undesired operation.

  2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Specific Absorption Rate (SAR) information:
This mobile phone meets the government’s requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.
FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types:
KJ7s (FCC ID: 2ADYY-KJ7S) has also been tested against this SAR limit.
The highest SAR value reported under this standard during product certification for use at the ear is 1.103 W/kg and when properly worn on the body is 0.314 W/kg.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 1.0 cm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.

HiOS runs on Android OS.
Android is a trademark of Google LLC.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals