ATOMSTACK R2 Roller Laser Rotary Set Instruction Manual
- June 20, 2024
- ATOMSTACK
Table of Contents
R2 Roller Installation Manual
Note: The picture is for reference only, subject to the real thing.
Please scan the two-dimensional code for more information.
F03-0136-0AA1
Versions：A
Packing List
| Roller body1Pcs
---|---
| Bracket1Pcs
| Heightened feet 4PCS
| Sequence line1Pcs
| Reverse sequence line*1Pcs
Installation Guide
Step 1: Roller
Step 2: Choose different gears to install according to the engraved items
Step 3: Adjust Gear
3.1 Select different gears according to the engraved items.| 3.2 Move the
roller to the appropriate gear and tighten the screw.
---|---
| 
3.3 Move the motor to tighten the belt and tighten the screws at
the bottom of the motor.| 3.4 Adjust the bracket installation: choose
different gears according to the
engraved special-shaped items, and move the bracket to a suitable position.
| 
Step 4: Wiring Instructions
The roller has two connecting wires, the black plug and the white plug, please
note that their wiring sequence is different and you need to connect
carefully.
The 4PIN white plug wire is used to connect ATOMSTACK laser engraving machine.
The 4PIN black plug wire is used to connect the third-party laser engraving
machine.
The roller kit supports ATOMSTACK and third-party laser cutters and engravers.
You need to connect it to the device and use the corresponding software to
operate it. If it cannot be connected, please change the order of the wires,
and the change process is shown in Figure 1.1-1.2.
|
---|---
1.1 Connection sequence of white plug wire| 1.2 Connection sequence of black
plug wire
Use LightBurn
-
Add “Enable Rotary” to main window
1.1 Click “Settings” on the toolbar
1.2 In the settings window, turn on the “Show rotary enable on
main window” button, and click OK.
-
Open the Rotary Setup window and set the parameters
2.1 Open the Rotary Setup window: Click “Laser Tools” on the toolbar and then click “Rotary Setup”
2.2 Set the correct parameters in the Rotary Setup window: As
shown in the figure Steps:
(1) Select the rotary type: Roller Type
(2) Turn on “Enable Rotary”
(3) Select the “Y Axis” rotary axis
(4) Input the parameters (fixed value) of the rotary equipment
(5) Enter the parameters of your engraved object: The actual measured diameter or circumference of the engraved object -
Import the pattern you want to engrave, set the size of the pattern, and set the engraving power and speed.
-
You can click “Frame” to preview the position of the pattern to be engraved, and then move the laser head to the expected position. It is recommended to use “Current Position” as the starting location, and click “Start” after completing the settings.
Customer service:
For detailed warranty policy, please visit our official website:
www.atomstack.com
For technical support and service, please email
support@atomstack.com
Manufacturer:
Shenzhen AtomStack Technologies Co.,Ltd
Address:
17th Floor, Building 3A, Phase II, Intelligent Park, No. 76, Baohe Avenue,
Baolong Street, Longgang District, Shenzhen, Guangdong, China
Zip code: 518172
Scan QR code:
QR code reader/barcode scanner or any app with a scanner
