Whirlpool WRS331SDHM 33 Inch Freestanding Side by Side Refrigerator User Guide
- June 9, 2024
- Whirlpool
Table of Contents
Whirlpool WRS331SDHM 33 Inch Freestanding Side by Side Refrigerator
OVERVIEW
- A. Water dispenser paddle
- B. Water dispenser spout
- C. Ice dispenser paddle
- D. Ice guide
TO DISPENSE WATER:
- Press a sturdy glass against the water dispenser lever. Hold the glass close to the water dispenser spout to ensure that the water dispenses into the glass.
- Remove the glass to stop dispensing
IMPORTANT: The small tray at the bottom of the dispenser is designed to catch small spills and allow for easy cleaning. There is no drain in the tray. To empty and clean the tray, push down on the back of the removable tray and pull out.
TO DISPENSE ICE:
Ice dispenses from the ice maker storage bin in the freezer when the dispenser
paddle is pressed. To turn off the ice maker, see the “Ice Maker and Storage
Bin” section in the Owner’s Manual. Before dispensing ice, select which type
of ice you prefer by pressing the “Ice Type” button. The display screen
indicates which type of ice is selected
For crushed ice, cubes are crushed before being dispensed. This may cause a slight delay when dispensing crushed ice. Noise from the ice crusher is normal, and pieces of ice may vary in size. When changing from crushed to cubed, a few ounces of crushed ice will be dispensed along with the first cubes.
-
Make sure the desired type of ice is selected.
WARNING
Use a sturdy glass when dispensing ice. Failure to do so can result in cuts -
Press a sturdy glass against the dispenser lever. Hold the glass close to the ice guide to ensure that the ice dispenses into the glass.
IMPORTANT : You do not need to apply a lot of pressure to the paddle in order to activate the ice dispenser. Pressing hard will not make the ice dispense faster or in greater quantities. -
Remove the glass to stop dispensing
Recommended Shelves Position
Pizza Pocket Assembly
Assembly Instructions
-
Insert three hooks on part “A” into their corresponding slots on part “B”. Ensure the hooks fit into the side opposite to the upper lip.
-
Assemble parts A and B at angle 90°.
NOTE : Do not exceed angle more than 90°. -
Place the assembly onto the studs on the liner wall.
Application Overview
™ ©2022 All rights reserved. Used under license in Canada
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>