ATOMSTACK F30 V2 Air Assist Kit Instruction Manual
- June 1, 2024
- ATOMSTACK
Table of Contents
ATOMSTACK F30 V2 Air Assist Kit
Product Specifications
- Model: A6 PRO/A12 PRO/A24 PRO
- Power Output Interface: DC diameter 3.5mm terminal
- Power Interface: DC diameter 5.5mm terminal
- Language Options: English, Deutsche, Italiano, Español
Product Usage Instructions
Wiring Diagram and Setup
The figure in the manual displays the wiring diagram for the A6 PRO/A12
PRO/A24 PRO air pump.
Flow Regulation Switch
The flow regulation switch controls the airflow. Ensure proper connection
of DC terminals as described in the manual.
Lightburn Software Settings
- Open Lightburn Settings.
- Select M7 or M8 settings.
- Click OK to confirm.
- Turn on the Air function within the software.
Precautions for Use
Do not bend the air tube excessively to avoid blocking the airway. This can
lead to damage to the air pump.
Frequently Asked Questions (FAQ)
-
Q: How should I connect the power output interface?
A: Connect the DC diameter 3.5mm terminal to the main board air pump power output interface. -
Q: Can I bend the air tube during operation?
A: Avoid bending the air tube excessively to prevent blocking the air line and potential damage to the pump.
Air Assist Instruction Manual
The figure shows the wiring diagram of A6 PRO/A12 PRO/A24 PRO air pump
DC diameter 3.5mm terminal, connected to the main board air pump power output interface, DC diameter 5.5mm terminal,con-nected to the air pump power interface.
Lightburn Software Settings
Open “Settings” -> Select “M7″or”M8” -> Click “OK” -> Turn on “Air”
Precautions for use
Be careful not to bend the hose excessively and block the airway.
Please note that the hose cannot be bent excessively to block the air line during pump operation. Avoid damaging the air pump.