SpeedyBee H31-4 M10 Mario Drone Instruction Manual
- June 13, 2024
- SpeedyBee
Table of Contents
SpeedyBee H31-4 M10 Mario Drone
Product Information:
The Mario is a drone designed for aerial photography and videography. It features a foldable frame design for easy transportation and storage. The drone comes with propellers, antenna mounts, and camera mounts for versatile usage. It also includes screws and hex wrenches for assembly.
Product Usage Instructions
- Step One: Start by rotating the frame arms to their corresponding positions one by one. Ensure that the positioning steel balls are aligned as shown in the picture. If the quick folding function is not used often, you can install the provided four M3*14mm screws after rotating the frame arms.
- Step Two: Use the H3 hex wrench to tighten clockwise the four M10 screws.
- Step Three: Install the propellers correctly. Ensure that all the blades are installed properly.
- Step Four: Properly install and lock the propellers as shown in the picture. Adjust the angle of the antenna mount to ensure that the receiver antenna does not interfere with the propellers.
- Step Five: For installation of 19mm and 20mm wide cameras, flip the mounts to resize easily. The standard installation width for the camera and mounts is 23mm in total inside.
- Step Six: For installation of T-shaped antennas, first remove the screws connecting the top plate and the antenna mount. Then follow the provided instructions for antenna installation.
- Step Seven: There are two ways to install the antenna: SMA or M4. Choose the appropriate method based on your antenna type.
Please refer to the user manual for more detailed instructions and safety guidelines.
-
Step One: Rotate the frame arms to their corresponding positions one by one. At this point, the positioning steel balls should be as shown in the picture below (if the quick folding function is not used often, you can install the provided four M3*14mm screws after the frame arms have been rotated).
-
Step Two: Use the H3 hex wrench to tighten clockwise the four M10 screws.
- Step Three: Properly install and lock the propellers as shown in the picture.
- Adjust the angle of the antenna mount to ensure that the receiver antenna does not interfere with the propellers.
- Method for opening side protective plate
-
Installation of 19mm and 20mm wide cameras. The standard installation width for the camera and mounts is 23mm in total inside. Flip the mounts to resize easily.
-
Installation of T-shaped antennas. (Before installation, first remove the screws connecting the top plate and the antenna mount.)
- Two ways to install the antenna
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>