ATOMSTACK E285 Cambrian Max 3D Printer Rubber Material Desktop Instruction Manual

June 4, 2024
ATOMSTACK

ATOMSTACK E285 Cambrian Max 3D Printer Rubber Material Desktop

Remove the existing extruder

There is 3pcs fixed screw at the back of extruder, use
the hexagonal wrench to loosen the screw ( no need to remove ), and then take out the existing extruder.

ATOMSTACK E285 Cambrian Max 3D Printer Rubber Material
Desktop-1

Unlock and unplug the FFC cable

The connection between the side port of the print head and the FFC cable is a snap-clamping method. Use the configuration tool screwdriver to insert from the side end of the print head (as shown in the figure below) to the two ends of the line buckle, and then pick up the buckles respectively and take them out FFC cable.

ATOMSTACK E285 Cambrian Max 3D Printer Rubber Material
Desktop-2 Insert the FFC wire into the new extruder
Carefully insert the FFC cable into the buckle, and press down the left and right ends of the buckle with a screwdriver.

Assemble the new extruder

Aim the screw holes on the back plate and fasten the extruder

ATOMSTACK E285 Cambrian Max 3D Printer Rubber Material
Desktop-4

Remark: The default extruder of 3D printer is E285, this page is the instruction for change the E285 to E175. E285 is for TPR 2.85mm filament, E175 is for PLA/PETG 1.75mm filament.

Extruder nozzle cleaning

  1. Turn on the device, click to enter the “Extruder” page, expand the material selection drop-down box, and select a material for preheating (select the material used for the last printing, here is the TPR material as an example). After selecting the material, the nozzle automatically starts heating. (Shown in the picture below)

  2. Observe the status bar at the top, wait for the print head to heat up to the target temperature, and clean the print head with a through needle.

  3. How to clean the E285 nozzle: push the feed handle above the nozzle, insert the through needle from above, and poke down with a certain force, the depth of the through needle inserted into the nozzle is about 3mm between the end and the nozzle shell, back and forth Pull and insert a few times until the nozzle has no residue to squeeze out. After cleaning, please use a shovel to scrape off the residue on the nozzle, otherwise it will affect the levelling and printing effect.ATOMSTACK E285 Cambrian Max 3D Printer Rubber Material Desktop-7
    Through needle is only for E285 print extruder, E175 print extruder is not available

  4. The E175 nozzle does not available for through-needle cleaning. After heating the temperature, directly insert the PLA material into the nozzle and eject the miserable material. It is also necessary to use a shovel to scrape off the residue on the nozzle to avoid affecting the levelling and printing effects.ATOMSTACK E285 Cambrian Max 3D Printer Rubber Material Desktop-8

Customer Service:

For more details about our warranty policy,please visit our official website:
www.atomstack3d.com
Any technical support please send us email at to:support@atomstack3d.com
Manufacturer: Shenzhen AtomStack Technologies Co., Ltd
Add: AB301, New Chabridge Industrial Park,No.3, Baolong 6 Rd., Longgang Dist.,Shenzhen Zip code 518116

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

ATOMSTACK User Manuals

Related Manuals