NEO Steam 1500 Professional Fog Machine User Manual
- June 16, 2024
- NEO
Table of Contents
NEO Steam 1500 Professional Fog Machine
OVERVIEW
STEAM 1500
PROFESSIONAL FOG MACHINE
THE STEAM 1500 is a compact fog machine with a robust and modern design.
It has a 1500-watt heater that allows it to start generating fog within three
minutes of turning it on. To facilitate manual control, it has an LCD screen.
It can also be controlled by DMX
Specifications
Effects
- Output: 21000 (ft3/min)
- Output Adjustment: 5 – 100%
- Fluid Consumption Rate: 162ml/min.
Control
- DMX Channels : 1CH
- DMX Modes: 1
- DMX Connectors : 3 pin 3 & 5 PIN XLR
- Primary/Secondary: NO
- On Board Control: Continuous fogging/Timing fogging
- Stand Alone : YES
- Display: LCD
- First Warm Up Time : 480s
- Max Continuous Output Duration: 16s
- No or Low Fluid Warning: NO
- Other Warnings: Overheat & No heating Warning
- Operate with exterior controller : YES
- Remote controller connectors : 1/4” JACK
- Manual fogging: YES
- Self-clean Function : NO
Power
- Input/Variable/Switchable : 230V or 240V
- Hz: 50 or 60Hz
- Heater Power Storage: 1500W
- Consumption: 1550W
- Fuse or No Fuse breaker : NFB16A (230V)
- Cable / Plug Type : H05VV-F3G1.0MM2, 1500MM + powerCON
- Approvals: ETL, CE, FDA, etc.
Fixture
- IP Rating : N/A
- Cooling: fan, air, cool, etc.
- Max Ambient Temperature (Ta) : 40°C
- Surface Temperature of body (Tc) : 60°C
- Hanging Bracket : YES
- Handle: NO
- Tank: 5L
- LED under Tank: NO
Dimensions
- Size (LxWxH): 436×321.5x414mm
- Weight: 12kg
Accessories (Included)
-
Controller : NO
-
Long press the Up/Down button to change the value continuously and fast.
-
Set values are automatically saved.
CONTINUOUS SMOKE OPERATION
Press the “Start/Pause” button to start continuous smoking, and then press the “Start/Pause” button again to stop smoking.
- During continuous smoking, the icon content is displayed. At this time, can also press the Up and Down keys to continuously adjust the smok volume (5-100).
TIMING SMOKE OPERATION
When the machine is “READY”, press the “Up/On” button to start timing smoking.
- The picture on the right shows the timing smoking start, with the D and I numbers jumping in turn, displaying the duration/interval countdown. Press the “Down / Off” button to stop timing smoking.
- Pressing the “Start/Pause” button during timing smoking can also activate continuous smoking, the icon content is displayed. Press the “Start/Pause” button again to stop continuous smoking and return to the timing smoking state.
DMX OPERATION
- The DMX control takes priority over the remotes and built-in control. When the machine receives a valid DMX signal, it is controlled by the DMX controller and ignores the remotes and built-in control, the icon screen is displayed. V represents the smoke volume controlled by DMX. In this state, you can still press the Up and Down to adjust the DMX Address.
DMX CHART
In the DMX state, the “Start/Pause” button serves as a manual smoking switch and pressing and holding this button sprays smoke at the maximum output; After releasing the “Start/Pause” button, stop manual smoking and return to the control state of the DMX.
FAULT WARNING
Flashing to display the following warning icons
- Indicates that the heater temperature is too high, or the temperature sensing wire discis connected.
- Indicates that the machine cannot heat up.
- Indicates that the fog liquid is used up or cannot be extracted. Add fog liquid to the tank and press the “Start/Pause” button to reset.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>