Keychron Q1 HE Wireless Custom Keyboard User Guide
- June 13, 2024
- Keychron
Table of Contents
Keychron Q1 HE Wireless Custom Keyboard
Connect 2.4 GHz Receiver
- Connect the 2.4 GHz receiver to my device’s usa port
Switch toggle to 2.4GHz mode
Connect Bluetooth
Connect Cable
Switch To The Right System
Please make sure the system toggle on the top left corner has been switched to the same system as your computer’s operating system.
The Keychron Launcher App
Please visit launcher.keychron.com to access
the Keychron online launcher app. This app enables users to remap keys, adjust
key actuation points, assign multiple commands to a single key, enter game
controller mode, and more.
If it cannot recognize your keyboard, please reach our support to get
instructions.
- The online launcher App can only run on the latest version of Chrome, Edge, and Opera browsers yet.
- The online launcher App only works when the keyboard is connected by wire to the computer.
The Layers
- There are four layers of key settings on the keyboard. Layer 0 and layer 1 are for the
- Mac system. Layer 2 and layer 3 are for the Windows system.
- If your system toggle is switched to Mac, then layer 0 will be activated.
- If your system toggle is switched to Windows, then layer 2 will be activated. Remember that if you are using it in Windows mode, please make changes to layer 2 instead of the top layer (layer 0).
- This is a common mistake people are making.
The Backlight
Adjust The Backlight Brightness
Warranty
- The keyboard is highly customizable and easy to rebuild.
- If anything goes wrong with any of the keyboard components of the keyboard during the warranty period, we will only replace the defective parts of the keyboard, not the whole keyboard.
Factory Reset
Troubleshooting
Don’t know what’s going on with the keyboard?
- Download the right firmware and QMK Toolbox from our website.
- Unplug the power cable and switch the keyboard to Cable mode.
- Remove the space bar keycap to find the reset button on the PCB.
- Hold the reset key first, then plug the power cable into the keyboard. Release the reset key after 2 seconds, and the keyboard will now enter DFU mode.
- Flash the firmware with the QMK Toolbox.
- Factory reset the keyboard by pressing fn + J + Z (for 4 seconds).
Step by step guide can be found on our website.
Not Happy
support@keychron.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>