Keychron V2 Max Wireless Custom Mechanical Keyboard User Guide

Quick Start Guide

V2 Max Wireless Custom Mechanical Keyboard

If you are a Windows user, please find the appropriate keycaps in the box, then follow the instructions below to find and replace the following keycaps.

1. Connect 24GHz Receiver
   Connect the 2.4GHz receiver to the device USB  Port. Note: For the best wireless experience, we recommend using the extension adapter for receiver and putting the 2.4GHz receiver somewhere on your desk close to your keyboard for a low rate of latency and fewer signal interferences.

2. Connect Bluetooth

3. Connect Cable.

4. SwitchTo The Right System
   Please make sure the system toggle on the top left comer has been switched tothe same system as your computer’s  operating system.

5. The VIA Key Remapping Software
   Please vist useviaapp to use the online VIA software to remap the keys.
   If the VIA cannot recognize your keyboard, please reach our support to get the instruction. * The online VIA software can only run on the latest version of Chrome, Edge, and Opera browsers yet.

• VIA only works when the keyboard is connected by wire to the computer. 6. The Layers
  There are five layers of key settings on the keyboard.
  The layer 0 is for the Mac system.
  The layer 1 is for the Windows system.
  The layer 2 is for the Mac Multimedia keys.
  The layer 3 is for the Windows Multimedia keys.
  The layer 4 is for function keys. If your system toggle is switched to Mac, then the layer 0 will be activated. If your system toggle is switched to Windows, then the layer 1 will be activated.

  7. The Backlight
     Press fn1 + A to change the lighting effect Press fn1 + caps lock to turn the backlight on/off

  8. Adjust The Backlight Brightness
     Press fn1 + S to increase the backlight brightness Press fn1 + X to decrease the backlight brightness

  9. Warranty
     The keyboard is highly customizable and easy to be rebuilt.
     If anything goes wrong with any of the keyboard components of keyboard during the warranty period, we will only replace the defective parts of the keyboard, not the whole keyboard.

  10. Factory ResetTroubleshooting? Don’t know what’s going on with the keyboard?
      1. Download the right firmware and QMK Toolbox from our website.
      2. Unplug the power cable and switch the keyboard to Cable mode.
      3. Remove the space bar keycap to find the reset button on the PCB.
      4. Hold the reset key first, then plug the power cable into the keyboard.
      Release the reset key after 2 seconds, and the keyboard will now enter DFU mode.
      5. Flash the firmware with the QMK Toolbox.
      6. Factory reset the keyboard by pressing fn2 + J + Z (for 4 seconds).
      *Step by step guide can be found on our website.

Not Happy
support@keychron.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>