Keychron Lemokey L1 Mechanical Keyboards User Guide

Keychron Lemokey L1 Mechanical Keyboards

The default system of this product is Windows.

Overview

Connect 2.4GHz Receiver

Connect the 2.4GHz receiver to the device’s USB port.

Switch toggle to 2.4GHz mode

Note:
For the best wireless experience, we recommend using the extension adapter for the receiver and putting the 2.4GHz receiver somewhere on your desk close to your keyboard for a low rate of latency and fewer signal interferences.

Connect Bluetooth

Switch the toggle to Bluetooth

Press Fn + 1 (for 4 seconds) and pair with a device named Lemokey L1.

Connect Cable

The VIA Key Remapping Software

• Please visit usevia.app to use the online VIA software to remap the keys.
• If the VIA cannot recognize your keyboard, please reach our support to get the instruction.
  • The online VIA software can only run on the latest version of Chrome, Edge, and Opera browsers.
  • VIA only works when the keyboard is connected by wire to the computer.

Switch to Mac

Please find the Mac keycaps in the box, and follow the instructions below to find and replace the following keycaps.

Use the online VIA to remap the Windows keys to Mac keys.

The Backlight

• Press Fn + Q to change the lighting effect
• Press Fn + Tab to turn the backlight on/off

Adjust The Backlight Brightness

• Press Fn + W to increase the backlight brightness
• Press Fn + S to decrease the backlight brightness

The Key Rollover

• Press Fn + N to switch N-key rollover/6-key rollover
• 6-key rollover: the keyboard can detect up to 6 simultaneous key inputs.
• N-key rollover: the keyboard can detect all key inputs without limit to the number of key presses.
  • The keyboard turns on the 6-key rollover by default.

Warranty

The keyboard is highly customizable and easy to rebuild. If anything goes wrong with any of the keyboard components of the keyboard during the warranty period, we will only replace the defective parts of the keyboard, not the whole keyboard.

Factory Reset

Troubleshooting? Don’t know what’s going on with the keyboard?

1. Download the right firmware and QMK Toolbox from our website.
2. Unplug the power cable and switch the keyboard to Cable mode.
3. Remove the space bar keycap to find the reset button on the PCB.
4. Hold the reset key first, then plug the power cable into the keyboard. Release the reset key after 2 seconds, and the keyboard will now enter DFU mode.
5. Flash the firmware with the QMK Toolbox.
6. Factory reset the keyboard by pressing Fn + J + Z (for 4 seconds).
   • Step by step guide can be found on our website.

Not Happy
support@lemokey.com.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>