Yealink SmartVision40 All In One Video Conference Camera Installation Guide
- June 13, 2024
- Yealink
Table of Contents
SmartVision40 Installation and Deployment Guide
Package Contents
TIP
- We recommend that you use the accessories provided or approved by Yealink. The use of unapproved third-party accessories may result in poor performance.
- Use the Yealink original power adapter to charge the endpoint only. The use of the third-party power adapter may cause damage to the endpoint.
Assemble Cable Cover
- Find the two slots on the back of SmartVision 40.
- Fit part A of the cable cover into the slots.
- Connect cables.
- Assemble part B and fix the screws.
Install SmartVision 40
Install SmartVision 40
-
Put on a Flat Surface****
|
---|---
On the desk| On the TV stand cart platform
(purchase separately) -
Mount on a Wall
Step 1: Determine SmartVision 40 position
The mounting height affects your camera view. The recommended height is 110 cm above the ground. Step 2: Mount the SmartVision 40 to the wall This deployment plan meets the ADA regulatory requirements in the United States. -
Embed in the wall
The mounting height affects your camera view. The recommended height is 110 cm above the ground.
NOTE
• Keep the front of the SmartVision 40 flush with the wall surface.
• The recommended on the left, right, and top sides of the SmartVision 40 is less than 0.5 cm.
• Leave a 5±0.5 cm distance between the back of the SmartVision 40 and the wall surface for cable connections. -
Mount on the Tabletop Mount
-
Mount above a TV or a display
NOTE
• The M-2 bracket can be inserted into the M-1 in two directions. Here, we will focus on one direction for illustration.
• Due to device weight, it is advisable to avoid mounting the device on slim TVs to prevent potential falls or damage to the screen.
Adjust Camera Tilt
Remote Control and Cable Ties Installation
| Remote Control Installation | Cable Ties Installation |
|---|---|
Hardware Interface
| No. | Item | Description |
|---|---|---|
| 1 | VCH | Connect to microphones or MVC-BYOD-Extender. |
| 2 | DC48V | Connect to a power adapter. |
| 3 | HDMI Out | Reserved port for future features. |
| 4 | USB Type-B (USB 3.0) | Connect to a PC as video output. |
| 5 | USB Type-A (USB 2.0) | Connect to USB flash driver to export device log. |
| 6 | Line In | Connect a 3.5mm audio connector to use the SmartVision 40 as an |
audio output device.
7| Line Out| Connect a 3.5mm audio connector to output audio to the hearing
assistance system.
8| Reset| Reset the SmartVision 40 to factory defaults.
9| USB Type-C (USB 2.0)| Pair with WPP30.
Connect SmartVision 40
LED Indicator
| LED Status | Description |
|---|---|
| Off | The SmartVision 40 is not properly connected to the mini-PC. |
| Flashing green | There is an incoming call. |
| Solid green | The SmartVision 40 is active. |
| Solid red | The SmartVision 40 is muted. |
| Solid orange | The SmartVision 40 is initializing or in sleep mode. |
| Flash orange | The SmartVision 40 is upgrading firmware. |
| Flash red and green alternately | The SmartVision 40 is paired with the |
VCM36-W.
Flash red| The SmartVision 40 is in recovery mode, and the firmware has not
been upgraded.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>