Yealink MTouchPlus-EXT Conferencing Touch Panel User Manual

Yealink MTouchPlus-EXT Conferencing Touch Panel

Specifications

• Product Name: MTouchPlus-EXT
• Power Supply: PoE or PoE switch
• Recommended Wall Installation Height: 1m~1.5m

Package Contents

Connection

• Assemble your MTouchPlus-EXT
• Connect your MTouchPlus-EXT

NOTE

1. MTouchPlus-EXT needs to be connected to the same LAN as MTouch Plus.
2. You can directly power MTouchPlus-EXT by using a PoE switch in the same LAN as MTouchPlus.

Pair your MTouchPlus-EXT with endpoint For MVC endpoints:
Enter the MTouch Plus IP address and PIN code according to the on-screen prompts in the MTouchPlus-EXT, then the system will be automatically paired with the MTouchPlus-EXT

TIP: Go to Device Status > IP in Yealink RoomConnect, and you can obtain the IP of MTouch Plus.

Table Installation

Put on the table

Paste on the table

NOTE: Please select the outlet hole according to your needs.

Fixed on a table

Drill three holes on the desktop.

Wall Installation

We recommend that the height of the wall installation is 1m~1.5m from the ground. Please select the outlet hole according to your needs. If the conference room environment allows, you can also wire through the wall.

Deployment
There are two deployment methods to power the MTouch Plus-EXT.

Multi-Controller

1. Deployment using the PoE power supply included in the package

   • a) Use a network cable to connect the Network port of the MTouch Plus-EXT to the PoE port of the PoE power supply included in the package.
   • b) Use a network cable to connect the Ethernet IN interface of the PoE power supply to the LAN.
   • c) Use a network cable to connect the Ext Touch port of the MTouch Plus under the same LAN.

2. Deployment using PoE switch MTouchPlus-EXT Installation

   • a) Use a network cable to connect the Network port of the MTouch Plus-EXT to the PoE switch.
   • b) Use a network cable to connect the Ext Touch port of the MTouch Plus to the same LAN as the MTouch Plus- EXT.

3. Record the IP address displayed on the left side of the MTouch Plus-EXT.

4. Click Room Controls – Status on the MTouch Plus and note the IP address of the MTouch Plus
   NOTE: If the above is done correctly, the IP address of the MTouch Plus- EXT and the IP address of the MTouch Plus should be on the same network segment, i.e., the first three digits should be the same.

5. Enter the IP address of the MTouch Plus on the MTouch Plus-EXT.

6. Enter the Pair Code displayed on the MTouch Plus (the Pair Code is shown on the top left of Room Controls Camera Control).

7. When pairing is complete, the same screen as the MTouch Plus is displayed on the MTouch Plus-EXT.

FAQ

• Q: What should I do if I cannot pair my MTouchPlus-EXT with an endpoint?
  • A: Make sure you are entering the correct IP address and PIN code as prompted on the screen. Verify that both devices are on the same LAN network.
• Q: Can I power my MTouchPlus-EXT using a different power source other than PoE?
  • A: No, it is recommended to use either the PoE power supply included in the package or a PoE switch for powering your MTouchPlus-EXT.
• Q: How can I check if my MTouchPlus-EXT is properly connected to the network?
  • A: You can check by verifying that the IP address displayed on your MTouchPlus-EXT matches the IP address of your MTouch Plus, ensuring they are on the same network segment.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>