Yealink Dual Screen Floor Stand Mounted Instructions
- May 15, 2024
- Yealink
Table of Contents
Yealink Dual Screen Floor Stand Mounted
Package Contents
The pictures of the endpoint and accessories in this guide are for reference only. Please use the accessories in the package, and follow the guide for installation. Yealink assumes no responsibility for any damage caused by improper installation methods.
Endpoint Installation
- The dual-screen floor stand is only suitable for installing MeetingBoard 65/ETV65.
- Take and place all components gently to avoid damage.
Insert the plug of the right mounting bracket into the left mounting bracket, and fix them with screws
Put down the stand and mouting bracket, fix the floor stand and mounting bracket with screws
When inserting, please ensure that the anti-misplacement device of the floor
stand corresponds to the pin groove of the mounting bracket, otherwise
insertion will fail.
Lock the scroll wheels
Install the hanging screws on the back of the endpoint
Mounting MeetingBoard
Adjust the handles on the back of the mounting bracket to ensure
The initial state of the handles on the mounting bracket is shown as follows,
with the handles at their lowest height position. Adjusting the handles
towards the other side will gradually increase the height on that side
.
Illustrate the following situations with examples:
- When the height of the endpoint on one side is inconsistent, adjust the handle on the lower side.
- Turn the handle counterclockwise to loosen it.
- Lift the lower side of the endpoint and push the handle towards the other side until the two sides of the endpoint are at the same height.
- Turn the handle clockwise to tighten it.
Connection
After installing the deployment, you can refer to Quick Setup to set up the MeetingBoard. After setup, please refer to Quick Usage to learn about general functions.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>