KORGOL CHINA Electric Standing Desk Instruction Manual
- June 14, 2024
- KORGOL
Table of Contents
KORGOL CHINA Electric Standing Desk
Important-Please read these instructions before assembly.
If you encounter any problems during installation, please feel free to contact
us!
- IMPORTANT INFORMATION
- READ CAREFULLY.
- KEEP THIS INFORMATION FOR FURTHER REFERENCE.
GENERAL GUIDELINES
- Please read the following instructions carefully and use the product accordingly.
- Please keep this manual and hand it over when you transfer the product.
- This summary may not include every detail of all variations and considered steps.
- Please contact us when further information and help are needed.
NOTES
- Please follow the assembly instructions precisely and only use the product as intended.
- If an odour is present when first opening the package, please leave the unwrapped product in a shaded and ventilated area for a few days to air out.
- Prior to assembly, please check the product for defects or missing accessories. If any defects are found or accessories are missing, do not use the product as damage or injury may occur;
- Please contact us for assistance and replacement.
- During assembly, please only slightly tighten all screws in their correct position first, then fully tighten them. A Philips screwdriver is recommended but not included.
- It is suggested you regularly check the product’s bolts and connections to ensure safe use.
- Assemble the item on a soft flat and clean surface to avoid scratches and damage.
WARNINGS
- Duis causes my and a spare Nation aerials away from children and pets as there
- Avoid sharp objects or corrosive chemicals to prevent damage to the product.
- Please open the item slowly and cautiously to avoid pinching your hands with metal joints, especially for children.
Components
- Please check you have all the pieces listed below
- Please check you have all the pieces listed below
Notice!
When the screw is tightened, do not continue to tighten it forcefully,
otherwise, the screw may be damaged.
Note: The horizontal bar on the iron connector should be perpendicular to the seam of the table panel splice.
- Install the other (6) -Support Beam on the other side in the same way as in step 3.
- Press the adjustment button on the wheel to brake.
Note: please pay attention to the direction of the Side brackets when installing.
- Stand the desk up and install (7) -Side brackets. At the same time, hooks can be installed to- together with the brackets, in any one of the four holes according to personal habits.
- Fishy in met hahe aen lock one pathie main shaft of the table leg Secondly, put the other side of the coupling rod into the pre-built rod on the motor leg and then lock the plastic nut again.
Note: Both ends of the sync rod should be inserted tightly into the end.
- Install K -AC Adapter, and B -Controller on the desktop.
- Stand the desk up and press the outlet box firmly into the desk.
-
Connect the Controller, AC Adapter, Power Cable and Left Leg.
-
Use D-Wire Clips to tidy up the wires.
CONTROLLER INSTRUCTION
Troubleshooting Guide
- If your standing desk does not work properly, you may need to reset it.
- If any error codes appear, you need to reset it.
Maintenance and Consideration
-
During daily maintenance, use a clean soft cloth to remove surface dust. Do not use a wet cloth or hard material to wipe the surface of the table.
Avoid contacting the surface with acid-based chemicals. -
For slight scratches, gently wipe with a soft cloth, you can smooth out scratches.
Avoid attaching tape directly to the outer surface of the metal feet to prevent paint from peeling.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>