QUIKCELL POWERBASE Premium Wireless Charging Pad User Guide

June 9, 2024
QUIKCELL

POWERBASE Premium Wireless Charging Pad
User Guide

SPECIFICATIONS

Power: 10W.
Output: 5W/7.5W/10W.
Input: DC5V 2A, 9V/2A.
Efficiency: ≥70%.
Transmission distance: ≤6mm.
Certifications: FCC, RoHS, and Qi.

WHAT’S INSIDE

  1. Wireless Charging Pad
  2. Type-C Charging Cable

WIRELESS CHARGING PAD CONTROLS

  1. Wireless phone charging pad
  2. LED charging indicator
  3. Type-C Input.

STEP 1
CONNECT TO POWER
Power your PowerBase by connecting the included cable to your wireless charging pad using the Type-C port and a power source. The LED light will be solid BLUE when the PowerBase is on and turn GREEN when it is ready to charge your device. Wall/Car charger not included

STEP 2
SETUP YOUR DEVICE.
Your Powerbase is designed to make charging as convenient as possible for you. To ensure proper charging takes place, please ensure your device is positioned in the correct placement on the charging pad.

STEP 3
START CHARGING
Place your wireless charging device on your PowerBase and look for the LED light to change from GREEN to pulsing BLUE to indicate charging has started. When fully charged, the LED light will turn GREEN to indicate charging is complete.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.

To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
© 2023 All rights reserved. Alphacomm, Quikcell, and PowerBase are registered trademarks of Alpha Comm Enterprises, LLC. All other trademarks are the property of their respective owners. Designed by Alpha Comm Enterprises, LLC at Diseñado por Alpha Comm Enterprises, LLC en 1500 Lakes Parkway, Lawrenceville, GA.30043.
**PowerBase®**
QC-PWRBASE3-BLK
FCC ID: 2A9G4-1070Q
HANK  ELECTRONICS VIETNAM LTD
No. 7,11 Street VSIP Tu Son . 16353 Bac Ninh
Province . Vietnam
This device complies with part 15 of the FCC Rules. Operation is subject to thefollowing two conditions: (1) This device may not cause harmful interference, an (2) this device must accept any interference received, including interference that may cause undesired operation.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals