QUIKCELL QFIT Wireless Neckband Headphones User Guide
- September 9, 2024
- QUIKCELL
Table of Contents
QUIKCELL QFIT Wireless Neckband Headphones
SPECIFICATIONS
Bluetooth Version: v5.4
Frequency : 20Hz-20KHz
Driver Output: 12mW
Supported Profile : A2DP / HFP / HSP / AVRCP
Playback Time: Up to 12 hours
Standby Time : Up to 180 hours
Battery Type: 3.7V Li-polymer rechargeable battery
WHAT’S INSIDE
- Wireless Neckband Headphones
- USB-A to USB-C Charging Cable
- Gel Ear-Tips
QFIT BUTTONS & CONTROLS
- Phone Button
- Short Press = play/pause music & answer/end phone calls
- Long Press = ignore/decline phone calls/power on/ off
- Double Press = re-dial the last number called
- [+] Button
- Short Press = skip to next song
- Long Press = increase volume
- [–] Button
- Short Press = skip to previous song
- Long Press = decrease volume
- Microphone
- LED Indicator Light
- USB-C Charging Port
- Magnetic Closure
STEP 1
CHARGE HEADPHONES
Plug USB-C into headphones and USB-A into a compatible port (such as a wall charger, car charger, or computer). Light is RED while charging and turns BLUE when fully charged.
*Wall/Car charger not included
STEP 2
PAIRING YOUR DEVICE
On the side of the QFit neckband, press and hold the PHONE button until you see the LED indicator flashing between red and blue and hear “Power on, pairing.” In your devices Bluetooth settings look for “QFit” to appear as an option and select to complete pairing.
STEP 3
START LISTENING
When you’re ready to use your QFit, press the PHONE button to turn your QFit
on.
Use the + and – buttons on the neckband to adjust volume and skip songs.
Use the PHONE button to play/pause music and answer, end, decline, and re-dial
phone calls, and power on/off.
ONE YEAR LIMITED WARRANTY
visit quikcell.com/warranty
Visitez le site Quikcell.com/warranty
ALPHACOMM
© 2024 All rights reserved. Alphacomm, Quikcell and QFit are registered trademarks of Alpha Comm Enterprises, LLC. All other trademarks are the property of their respective owners. Designed by Alpha Comm Enterprises, LLC at 1500 Lakes Parkway, Lawrenceville, GA 30043.
QFIT
QFITV2-BLK, QFITV2-BLU, QFITV2-WHT
FCC ID: 2 BFXU – LEB 42
Alpha Comm Enterprises, LLC
1500 Lakes Parkway Lawrenceville GA 30043.
1-888-951-0909
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
FCC Caution.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>