WHITESTONE DOME Premium Genuine Film Galaxy Z Flip 3/4 User Guide

WHITESTONE DOME Premium Genuine Film Galaxy Z Flip 3/4

• Please check all manual and attachment videos before using the product.
• Products damaged or damaged by user negligence cannot be exchanged or refunded.

Please make sure to check manual and installation video before using the product.
Products damaged or damaged by user usage, cannot be exchanged or refunded.
After checking the Quick guide, check the User guide.

< Quick guide / User guide>
Please check the model and components before using the product.

• Match your device model with the product in advance.
• Please check all the components listed on the page3 and if there is any problem with the components, please contact us before the installation.

Cautions before Dome silk installation

• Watch the Installation video and manual carefully before start to install.
• Please see all introductions, since each device has different installation way.
• Install the film after removing any film on the screen.
• Please avoid a dusty place.
• Be careful of any impacts while getting out the jig from the box in order to prevent any damage.
• Be careful not to force the jig apart or break it. If there is a problem with the subsidiary materials, please do not attempt installation and contact customer service immediately.

Components

Reference

• There may be differences in components depending on the model.
• To improve the product, component’s appearance or specifications etc. can be change without prior notice.

*There are differences in components depending on the model, so please check the components of the product purchased before attaching it.

Installation

STEP1
Remove the protection film attached to your device using the Remover.

STEP2
Connect the Align block to top part of the JIG.

STEP3
Insert the device into the JIG in correct direction.

STEP4
Clean the display with alcohol wipe and cleaning cloth.
Then, remove any dust with dust removal sticker.
Close the device to the stopper.

STEP5

Hold the top part of the film as shown, and bend the [1 sticker] as shown in [Figure 1]. Like [Figure 2] Make sure that the protective film and pet film are properly separated and slowly remove the protective film. If it is as shown in [Figure 3], attach the protective film as if it is in the first state and remove it carefully so that only the protective film can be removed.

• **** Please do not touch adhesion surface.
  

STEP6
Flip the film with the protective film removed so that the top/bottom text are visible to the front.

1. Insert the top part of the film into the Align block.
2. Insert the bottom part of the film into the bottom part of the JIG.

• Please do not touch adhesion surface.
• Make sure the film does not stick onto the device.
  

STEP7
Hold the top end of the film and slowly and forcefully push up with the squeegee from the bottom of the jig to the top while maintaining squeegee in a lean angle. Push the squeegee all the way to the end.

• **** Bubble might be appeared if you push the squeegee too fast.

STEP8

Remove the guide film from Jig’s hole while pressing the ①-top/②-bottom of the film with a squeegee. ③Push the film entirely to the short side of the squeeze.