WHITESTONE DOME GLASS UV GEN Film Galaxy S22 Ultra/ Note 20 Ultra User Guide

WHITESTONE DOME GLASS UV GEN Film Galaxy S22 Ultra/ Note 20 Ultra

User Guide

• Please check all manual and attachment videos before using the product.
• Products damaged or damaged by user negligence cannot be exchanged or refunded.

Please make sure to check manual and installation video before using the product.
Products damaged or damaged by user usage, cannot be exchanged or refunded.

After checking the Quick guide, check the User guide.

< Quick guide / User guide>

Please check the model and components before using the product

• Match your device model with the product in advance.
• Please check all the components listed on the page3 and if there is any problem with the components, please contact us before the installation

Cautions before installation

• Surface scratch restoration is limited to minor scratches.
• It can be immediately restored when writing with a stylus pen gently.
• If pressing too hard, the glass could be restored in a few days, but may remain small stains.
• No exchanges or refunds for the customer’s fault.

UV Curing Machine

• UV curing machine recommends using 2A or higher power.
• When using low current (A) power (laptop or power bank) After the 2nd curing, proceed with 2~3 additional curing.
• Check that the UV curing machine lights up.

Components

Reference

• There may be differences in components depending on the model.
• To improve the product, component’s appearance or specifications etc. can be change without prior notice.
• Some components can be purchased separately if necessary.

Before installation

Check that the UV curing machine lights up.
Please avoid a dusty place or sunlight.

STEP 1

1. Insert the adapter into the device.

2. Use the alcohol wipe and the cleaning cloth to wipe down the screen.
   Remove any dust from your screen with dust removal sticker.

3. Attach the stopper. Close the device to the stopper.

STEP 2

1. After removing the liner film from the back of the film
2. Insert by matching the film bottom hole and adapter hole.
3. Attach & align the film to the camera hole.
4. If the position is not correct, remove and reattach.
5. After removing the adapter,remove dust and air bubbles by gently pushing with a squeegee.

STEP 3

1. Tilt the top protective film 180° and push with a squeegee to attach it.
2. Tilt the bottom protective film 180° and push with a squeegee to attach it.
3. Attach by pushing the side by hand.
   (Direction: center of glass → outside/bottom of device → top)

STEP 4

1. Press the line with a squeegee.
2. With a dust removal sticker remove the front protective film.
3. Curing time : 60 sec each for bottom -> middle -> top part

Please do not press the bubbles or lines after the installation, it will be naturally disappeared.

Warning

Please check the installation Guide

Precautions after installation

• Bubbles or lifting may occur by physical impacts such as drop impact, incompatible phone cases use, excessive strength while cleaning with alcohol wipes or etc.
• No refund or exchange for any type of user damages

CONTACT US

feedback@whitestonedome.com

HOMEPAGE

www.whitestonedome.com > WARRANTY REQUEST

We always provide friendly and fast service to your questions
WHITESTONE Ltd.

27, Baekseokgongdan7-ro, SeoBuk-gu, Cheonan-si, Chungcheongnam-do, Republic of Korea

The unique Component Manufacturer, Whitestone (www.whitestonedome.com) for Mobile devices. Copyright ⓒ Whitestone Ltd. All rights reserved.

References

• Screen Protector Solution | Patented Liquid Dispersion Tempered Glass – Whitestonedome

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>