EcoDim Led Snoerdimmer User Manual
- June 7, 2024
- EcoDim
Table of Contents
EcoDim Led Snoerdimmer User Manual
This cord dimmer has been specially developed to be able to dim dimmable LED
lamps. The cord dimmer works from LED power of 0W and you can connect
a maximum LED power of 50W to the cord dimmer. For halogen lamps and light
bulbs the maximum is 100W.
– MIN / MAX settings for optimal light stability
– Memory for the last selected brightness
– Soft-start system
– Push-turn button
– Available in white and black
Connection diagram
MIN/MAX Settings
For optimal results, you can adjust the lights with the MIN and MAX settings.
MIN adjustment:
Switch on the lighting using the dimmer shaft. Then use a screwdriver to slowly turn the MIN potentiometer (back of the product) to the right for stable light. Is the light already stable? Then slowly turn the MIN counterclockwise for even better dimmability until the lights start flashing just before the point. That is the best dimmability of these LED lamps.
MAX adjustment:
Switch on the lighting using the dimmer shaft. Then turn the dimmer shaft as
far to the right as possible (maximum light output). Are the lamps flashing?
Then turn the MAX potentiometer (back of the product) slowly to the left with
a screwdriver for stable light in the maximum light position. Is the light
already stable? Then turn the MAX to the right for the maximum light output of
these LED lamps.
ECO-DIM.08
Input voltage 220-240V Vac, 50Hz
Load wattage 0-50W LED 10-100W halogen lamps/
light bulbs
Suitable for LEDs, halogen lamps, light bulbs
Type of dimmer R,C Phase cut
Operation Push-turn button
Working temperature max. 35°C
Dimensions 96.7 x 30.4 x 39.4 mm
Weight 30 gr.
√ 0-50W LED
√ Phase cut (R, C)
√ Optimal dimmability and light stability
√ MIN. and MAX. adjustment
√ Protection against interference signals
√ Noiseless dimming
√ Soft start system
√ Press / rotary knob
Cord dimmer with rotary knob and both MIN and MAX adjustment. This allows you to get the best dimmability from every LED lamp. In addition, you can simply use the well-known push / turn knob (instead of a push button). Much more user-friendly to operate!
√ Overload Protection
√ Short Circuit Protection
√ Over Temperature Protection
Installation
Stap 1: Loosen the screws in the bottom of the cord dimmer (G)
Stap 2: Remove the dimmer button and the top of the cord dimmer (A, B)
Stap 3: Loosen the screws to be able to attach the installation wire later (D)
Stap 4: Strip the wires to provide good connections
Stap 5: Place wires L (brown) and N (blue) in the connections (D)
Stap 6: Screw the wires into the connections (D)
Stap 7: Now repeat steps 3 to 6 for the other side (connection of the cord to
the lamp)
Stap 8: Check if the wires are securely tightened
Stap 9: Put part F (bottom) and part B (top) together again
Stap 10: Tighten the screws in the bottom of the cord dimmer (G)
Stap 11: Place the dimmer knob back on to dimmer pin (A)
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>