SALSIFY ANT-5-4T Bi-Level Microwave Motion Sensor for High Bay Light Instructions
- June 6, 2024
- SALSIFY
Table of Contents
ANT-5-4T Bi-Level Microwave Motion Sensor for High Bay
Light Instructions
INTRODUCTION
The ANT-5-4T is a motion sensor that dims lighting from high to low based on
movement. This slim, low-profile sensor is designed for installation inside
the bottom of a light fixture body.
The sensors use microwave sensing technology that reacts to changes in
movement within the coverage area.
Once the sensor stops detecting movement and the time delay elapses lights
will go from high to low mode and eventually to an OFF position if it is
desired. Sensors must directly “see” the motion of a person or moving object
to detect them, so careful consideration must be given to sensor luminaire
placement and lens selection. Avoid placing the sensor where obstructions may
block the sensor’s line of sight.
SPECIFICATIONS
| Power supply | 12V-24V DC, >50mA |
|---|---|
| Dim control output | 0-10V, max. 25mA sinking current |
| HF System | 5.8GHz±75MHz |
| Transmission power | <0.2mW |
| Detection radius | 20%/50%/75%/100%(1-8m) |
| Mounting height | Max 40ft.(12meters) |
| Time setting | 10s/1min/5min/10min/15min/20min/30min/60min |
| Light-control | 24H/10LUX/30LUX/50LUX |
| Temperature | -4°F — +140°F (-20°C — +60°C) |
| IP rating | IP65 |
WARNING
NOTE: Warm-up time is 15seconds. After the sensor connects the input to
power the first time, the light will keep on 15seconds, then go to dimming to
work normally.
NOTE: Factory Default Setting: 100% sensitivity, Hold on time: 5min,
Daylight sensor is Q, Dimming level:30%, Dimming time: 30minitues.
NOTE: Any setting changed by remote control, the led light that the
sensor connects will be on/off as confirmed.
CORRIDOR FUNCTION
This function inside the motion sensor to achieve tri-level control, for some areas which require a light change notice before switch-off. The sensor offers 3 levels of light: 100%–>dimmed light (natural light is insufficient) –>off; and 2 periods of selectable waiting time: motion hold-time and stand-by period; Selectable daylight threshold and freedom of detection area.
|
---|---
With sufficient natural light, the light does not switch on when presence is
detected.| With insufficient natural light, the sensor switches on the light
automatically when presence is detected.
|
After hold-time, the light dims to stand-by level if the surrounding natural
light is below the daylight threshold.| Light switches off automatically after
the stand-by period elapses.
DAYLIGHT SENSOR FUNCTION
Open the daylight sensor by pushing when the remote control is in setting condition.
|
---|---
The light switches on at 100% when there is movement detected.| The light dims
to stand-by level after the hold-time.
|
The light remains at a dimming level at night.|
|
When the natural light level exceeds setpoint off to light, the light will
turn off even when the space is occupied.| The light automatically turns on at
10% when natural light is insufficient (no motion).
Settings on this demonstration:
Hold-time: 30min
Setpoint on:50Iux
Setpoint off:300Iux
Stand-by Dim: 10%
Stand-by period: +o
(when the smart photocell sensor opens, the stand-by time is only +oo)
SENSOR COVERAGE
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>