bebird Smart Visual Ear-Clean Rod User Manual
- June 7, 2024
- bebird
Table of Contents
bebird Smart Visual Ear-Clean Rod
Open bird C3
- Scan QR code to download app
- Open Bebird app and select Bebird C3
- Press and hold the power key to turn on the ear cleaning rod
Connect product wifi
- Connect Product Wi-Fi “bebird-XXXX”
- Back to Bebird app Enter and start to use it
Accessory replacement
Bayonet type ear spoon’s end It can be replaced by side folding
Accessory
-
Q-elastic ear spoon x 1
The world’s first version which is combined PC with silica gel -
Transparent ear spoon x 2
Dig the ear canal deeply and take out a large amount of earwax
Product size
Hazardous substance
Part name
| Hazardous material|
---|---|---
(Pb)| (Hg )| (Cd )| (Cr(VI))| (PBB )| (PBDE)
Printed Circuit Components
Case
Plastic rubber accessory
–
|
x
|
0
|
0
|
0
|
0
|
0
0
|
0
|
0
|
0
|
0
|
0
0
|
0
|
0
|
0
|
0
|
0
This form is formulated in accordance with SJ/T 11364
O: represent the hazardous material ratio is below GBff26572-2011
X: represent the hazardous material ratio is over GBff26572-2011
Troubleshooting
Trouble | Solution |
---|---|
starting up and no response | Please try several more times according to the |
correct boot-up method Please use your own charging equipment for charging.
The charging time is about 1 h
Camera does not turn on| Shut down and restart the ear-cleaning rod
APP quit quickly| Delete the existing APP and re-
scan the QR code for installation
Rod’s power indicator is red| Please use your own charging equipment for
charging.
The charging time is about 1 h
The product failed to display the real-time image after successfully
connecting the Bebird APP| Disconnect the phone from WiFi, restart the product
and reconnect the WiFi
WiFi connection is unstable, sometimes it is disconnected in seconds| Restart
ear clean rod, reconnect Bebird APP
If the above operation still fails to solve the problem, please contact Bebird
Customer Service We will provide you practical solutions
Attention
-
When cleaning lens, please wipe it carefully with professional alcohol cotton swab.
-
Before use it, please check the surrounding environment.
Do not use the product in the environment where someone runs, in order to avoid strike. -
This product is not suitable for children under one year old.
-
It is forbidden for children to use this product alone in order to avoid accidental harm.
-
Do not use the endoscope in liquid to avoid damage caused by immersion.
-
Product which is built-in rechargeable lithium batteries, if not often used, must also be charged once a month.
-
Avoid product exposure to sunshine directly, especially the accessories in the barrel, in order to avoid softening.
-
During using it, the temperature of the product will rise slightly (up to 35 C). Please rest assured that it can be used.
-
In order to ensure the best using experience, please keep the child in a sitting position and operate the product horizontally.
-
For your ear cleaning experience, please replace the spoon end after more than 6 months of use.
Product parameters
Brand bebird
Product Name Smart visual ear-clean Rod
Model C3
Rod weight 16g
Network standard IEEE 802.11b/g/n
Antenna Internal FPC antenna
Working frequency 2.4
Image transmission rate 30fps
image sensor CMOS
Working temperature -10 – 50°C
Battery 250mAh lithium battery
Battery life about 60 minutes
Charging time 1h
Input current DC 5V 300mA
Lens diameter 4.5mm
Optimum focal length 1.5 – 2cm
Pixel 3M
Gravity Sensor 3 axis
Warranty
User name: Telephone number:
Address:
Seller: Telephone number:
Promote the e r a of intelligent ear cleaning
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference. and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device. pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and. if not installed and used in accordance with the instructions. may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on. the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition with out restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>