RunCam TX200U BFCMS Control 5.8G 48CH 25/200mW Video Transmitter User Guide
- June 7, 2024
- RunCam
Table of Contents
RunCam TX200U BFCMS Control 5.8G 48CH 25/200mW Video Transmitter
Frequency Setup
Lock mode:
Red LED flashes, only 25mW & limited frequency available;
Unlocked mode:
Red LED keeps on, 200mW & all 48 channels available; By long pressing button
for 10 seconds, you can switch between the two modes.
Note:
Before you get TX200 unlocked, it is highly recommended to know about the
rules and regulations in your country about the frequency to avoid a fine or
confiscation of your device.
1 Blue LED for Channel
Short press the button to switch the Channel, Channel 1/2/3/4/5/6/7/8 in
sequence. For each short press, the Blue LED flashes once, and only when it’s
under the Channel 1, the LED is always on.
6 Red LED for Band
Long press the button two seconds to switch the Band, Band 1/2/3/4/5/6 in
sequence. For each long press, the six Red LEDs light in turn.
1 Orange LED for Power
Long press the button five seconds to switch the power, on is 200mw, off is
25mw, lock mode is limited to 25mw.
Parameter
Frequency Channel: 5.8G 48CH
Output Power: 25mW / 200mW
Working Current: 5V@150~400mA
Voltage out: 5V@max 250mA
Voltage in: 1S 3.5-5.5V
Video Input Impedance: 75 Ohm
Antenna : U.FL 5.8G 2dB Omni antenna
Weight: 2.5g (with antenna)
PCB Size: 19mm*19mm
Instruction diagram
-
Flight controller wiring
Note: Take UART4 for example
-
Betaflight 3.1 or above setting
-
Remote control
Note: Take Mode-2 for example
- If you connect VTX to Flight Controller (Beta Flight 3.3 or above) IRC Tramp protocol, the VTX will be controlled by Flight Controller and its frequency will be changed to F1 5740 and the button on VTX will give no more reaction.
- If you need to get 200mW & all 48 channels unlocked, please long press the button on VTX for 10 seconds till the red LED is always on.
BFOSD 25mw VTX 25mw
BFOSD 100mw VTX 25mw
BFOSD 200mw VTX 200mw
BFOSD 400mw VTX 200mw
BFOSD 600mw VTX 200mw
Frequency Table
