motorola Bluetooth Headset User Guide
- June 7, 2024
- Motorola
Table of Contents
Quick Start Guide
MODEL: MH002 W
Product ID: MHOO2W
FCC ID: VLJ-MHOO2W
IC: 4522A-MHOO2W
At a glance
Connect & go
Buttons operation
To…|
---|---
answer a call| Press
reject a call| Press and hold until you hear a tone.
redial the last call| Press and hold until you hear a tone.
mute or unmute| Press and hold the Volume button.
end a call| Press
Note: Some features are phone/network dependent.
Note: Using a mobile device or accessory while driving may cause distraction
and may be illegal. Always obey the laws and drive safely.
Connect to the second device
Connect your headset with two devices at the same time:
Before pairing the second device, turn off Bluetooth on the previously paired
device and restart the headset Power. Now pair your second device following
“Connect & go”
Once paired to the second device, your headset is ready to connect with either
or both devices. Normal headset features work with both devices.
Additional status light
status light | headset |
---|---|
rapid red flashes | battery low |
steady red | charging – low battery level |
steady blue | charging – battery full |
General information
Email: support@motorolastore.com
On the Web: motorolastore.support
Consumer Products and Accessories Limited Warranty (“Warranty”)
Thank you for purchasing this Motorola branded product manufactured under
license by Binatone Electronics International LTD (“BINATONE”).
What Does This Warranty Cover?
Subject to the exclusions contained below, BINATONE warrants that this
Motorola branded product (“Product”) or certified accessory (“Accessory”) sold
for use with this product that it manufactured to be free from defects in
materials and workmanship under normal consumer usage for the period outlined
below. This Warranty is your exclusive warranty and is not transferable.
Who is covered?
This warranty extends only to the first consumer purchaser and is not transferable.
What will BINATONE do?
BINATONE or its authorized distributor at its option and within a commercially reasonable time, will at no charge repair or replace any Products or Accessories that do not conform to this Warranty. We may use functionally equivalent reconditioned/refurbished / pre-owned or new Products, Accessories or parts.
What Other Limitations Are There?
ANY IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL BE LIMITED TO THE DURATION OF THIS LIMITED WARRANTY, OTHERWISE, THE REPAIR OR REPLACEMENT PROVIDED UNDER THIS EXPRESS LIMITED WARRANTY IS THE EXCLUSIVE REMEDY
OF THE CONSUMER, AND IS PROVIDED IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED. IN NO EVENT
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This device contains license-exempt transmitter(s)/ receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.