DYNO JET PC6-16077 Power Commander 6 Installation Guide
- June 3, 2024
- DYNO JET
Table of Contents
POWER COMMANDER 6
Install Guide for: PC6-16077
Model coverage: 2019-2021 Honda CB300R
PARTS LIST
1 POWER COMMANDER 6
1 INSTALLATION GUIDE
1 USB CABLE
2 DYNOJET DECALS
2 POWER COMMANDER DECALS
2 VELCRO STRIPS
1 ALCOHOL SWAB
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION.
THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION.
IPC6-16077.01
INPUT ACCESSORY GUIDE
OPTIONAL ACCESSORY INPUTS
Map
(Input 1 or 2) The PC6 has the ability to hold 2 different base maps. You
can switch on the fly between these two base maps when you hook up a switch to
the MAP inputs. You can use any open/close type switch. The polarity of the
wires is not important.
Shifter
(Input 1 or 2) Used for clutch-less full throttle upshifts. Insert the wires
from the Dynojet quick shifter into either Input 1 or Input 2. The polarity of
the wires is not important. Set to Input 2 by default.
Speed
If your application has a speed sensor then you can tap into the signal
side of the sensor and run a wire into this input. This will allow you to
calculate gear position in the Control Center Software. Once gear position is
setup you can alter your map based on gear position and setup gear dependent
kill times when using a quickshifter. .
Analog
This input is for a 0-5v signal such as engine temp, boost, etc. Once this
input is established you can alter your fuel curve based on this input in the
Power Core software.
Launch
You can connect a wire to either Input 1 or Input 2 and then the other end to
a switch. This switch when engaged (continuity) will only allow the RPM to be
raised to a certain limit (set in the software). When released, you will have
full RPM.
WIRE CONNECTIONS
To input wires into the PC6 first remove the rubber plug on the backside of
the unit and loosen the screw for the corresponding input. Using a 22-24 gauge
wire, strip about 10mm from its end. Push the wire into the hole of the PC6
until it stops and then tighten the screw. Make sure to reinstall the rubber
plug.
NOTE: If you tin the wires with solder it will make inserting them easier.
INSTALLING THE POWER COMMANDER 6
-
Remove the seat. Remove the side covers. Remove the plastic around the fuel tank.
-
Secure the PC6 module on the back side the air box at the location shown.
Use the supplied Velcro strips to secure the module. Clean surfaces with the alcohol swab before attaching the Velcro. -
Route the PC6 wiring harness forward following along the left side frame rail.
-
Unplug the bike’s ECM.
-
Plug the PC6 wiring harness in-line of the bike’s ECM and stock wiring harness.
-
Reinstall the bodywork and the seat.
Download the latest map files from our web site at dynojet.com/tunes.
PUSH THE LIMIT
2191 MENDENHALL DRIVE, NORTH LAS VEGAS, NV 89081
–800-992-4993 –
DYNOJET.COM
© 2007-2022 DYNOJET RESEARCH ALL RIGHTS RESERVED
Documents / Resources
| DYNO
JET PC6-16077 Power Commander
6
[pdf] Installation Guide
PC6-16077 Power Commander 6, PC6-16077, 2019-2021 Honda CB300R, Power
Commander 6, Commander 6
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>