CALIBER CNC 16 Universal Tablet Holder User Guide

CALIBER CNC 16 Universal Tablet Holder

Caliber hereby declares that the item CNC 16 is in compliance with the essential requirements and other relevant provisions of Directive 2011/65/EU (Rohs).

Headrest Holder

1. Anti-slip silicone pads
2. Soft rubber grip
3. Fixation lock
4. Direction adjustment knob
5. Anti-Slip Pad

1. Keep the bar in front and slide the adjustable hooks behind your headrest posts and tighten them by screwing the fixation locks.
2. Loosen the direction adjustment knob to be able to adjust the holder: 45° tilt and 360° rotating. Tighten to fixate chosen view angle.
3. Adjustable grip for your device to fit .
   (retractable: 24,5 till 40,5 cm/ 9.6 till 15.9 inch)

Suction Cup Holder

1. Anti-slip silicone pads

2. Soft rubber grip

   • Adjustable for your device to fit
     (retractable: 24,5 till 40,5 cm/ 9.6 till 15.9 inch)

3. Fixation lock adjustable arm

   • Loosen to be able to adjust the arm in height. Tighten to fixate the chosen position

4. Suction cup and lock lever

   • Can be placed either on the windshield of a vehicle or on a smooth table surface.
   • Push down the lever to secure the position.

5. Direction adjustment knob

   • Loosen the direction adjustment knob to be able to adjust the holder: 45° tilt and 360° rotating. Tighten to fixate chosen view angle.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>