BRAYER BR3021BK Hair Dryer Instruction Manual

: June 4, 2024
: BRAYER

Table of Contents

HAIRDRYER BR3021BK
SAFETY MEASURES AND OPERATION RECOMMENDATIONS
BEFORE THE FIRST USE
USING THE HAIRDRYER
CLEANING AND MAINTENANCE
STORAGE
TECHNICAL SPECIFICATIONS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

BR3021BK Hair Dryer
Instruction Manual

HAIRDRYER BR3021BK

The hairdryer is intended for hair drying and styling.

DESCRIPTION

BRAYER BR3021BK Hair Dryer - Discription

Operation mode switch (0/1/2)
«Cool shot» button « »
Nozzle
Body
Air inlet grid
Wall-mounted holder of the hairdryer
Power switch
Power cord

ATTENTION!

Do not use the unit near water in the bathrooms, showers, swimming pools, etc.
After using the hairdryer in a bathroom, you
should take the power plug out of the main socket, as the closeness of water is dangerous even if the unit is switched off.
For additional protection, it is reasonable to install a residual current device (RCD) with a nominal operating current not exceeding 30 mA into the mains of a bathroom. To install it, contact an electrical technician.

SAFETY MEASURES AND OPERATION RECOMMENDATIONS

Read the operation manual carefully before using the unit; after reading, keep it for future reference.

Use the unit for its intended purpose only, as specified in this manual.
Mishandling the unit can lead to its breakage and cause harm to the user or damage to his/her property and it is not covered by warranty.
The hairdryer is intended only for styling slightly wet and dry hair, do not use the unit for the styling of wet hair or synthetic wigs.
Make sure that the operating voltage of the unit indicated on the label corresponds to your home mains voltage.
Do not use the unit when you are drowsy.
Do not use the unit outdoors.
It is not recommended to use the unit during lightning storms.
Protect the unit from blows, drops, vibrations, and other mechanical stress.
Never leave the plugged-in hairdryer unattended.
Do not use the unit near heating appliances, heat sources, or open flames.
Do not use the unit in places where aerosols are used or sprayed and close to inflammable liquids.
Do not use the unit near a kitchen sink, in bathrooms, near swimming pools, or other containers filled with water.
Do not use the unit while taking a bath.
Do not hang or keep the unit in places where it can fall into a bath or a sink filled with water; do not immerse the unit body, power cord or power plug into water or other liquids.
If the unit is dropped into water, unplug it immediately; only then take the unit out of the water.
Do not let the power cord touch hot surfaces and sharp edges of furniture.
Unplug the unit after usage or before cleaning. When unplugging the unit, hold the power plug and carefully remove it from the mains socket, do not pull the power cord, as this can lead to its damage and cause a short circuit.
Do not touch the mixer body, the power cord, and the power plug with wet hands.
Avoid contact with heated surfaces with your face, neck, and other parts of your body.
Do not direct hot air into your eyes or other heat-sensitive parts of your body.
Never insert any foreign objects into any unit body openings.
Do not block the air inlets of the hairdryer, and do not place it on a soft surface, where the air inlets may be blocked. Keep the air inlets free of lint, dust, hair, etc.
Clean the unit regularly.
Unplug the unit after usage and before cleaning.
For a child, safety reasons do not leave polyethylene bags used as packaging unattended.
ATTENTION! Do not allow children to play with polyethylene bags or packaging film. The danger of suffocation!
The hairdryer is not intended for use by children.
Do not leave children unattended to prevent using the unit as a toy.
Do not allow children to touch the operating surface, unit body, power cord, or power plug during the operation of the unit.
Close supervision is necessary when children or disabled persons are near the operating unit.
During the unit’s operation and breaks between operation cycles, place the unit out of reach of children.
The unit is not intended for usage by physically or mentally disabled persons (including children) or by persons lacking experience or knowledge if they are not under the supervision of a person who is responsible for their safety or if they are not instructed by this person on the usage of the unit.
Regularly check the integrity of the power cord.
If the power cord is damaged, it should be replaced by the manufacturer, maintenance service, or similarly qualified personnel, to avoid danger.
Do not repair the unit by yourself. Do not disassemble the unit by yourself; in case of any malfunction or if the unit is dropped, unplug it and apply it to the service center.
To avoid damages, transport the unit in its original package only.
Keep the unit in a dry cool place out of reach of children and disabled persons.

THE UNIT IS INTENDED FOR HOUSEHOLD USAGE ONLY. DO NOT USE THE HAIRDRYER FOR COMMERCIAL OR LABORATORY PURPOSES.

BEFORE THE FIRST USE

After the unit’s transportation or storage at a negative temperature, unpack it and wait for 3 hours before using it.

Unpack the unit and remove all the packaging materials.
Keep the original package.
Check the delivery set.
Read the safety measures and operating recommendations.
Examine the unit for damages; if the unit is damaged, do not plug it into the mains.
Make sure that the indicated specifications of the power supply voltage of the unit correspond to the specifications of your mains.
Wipe the unit with a clean, slightly damp cloth to remove dust, and then wipe it dry.

WALL-MOUNTED HOLDER OF THE HAIRDRYER

To reduce the risk of electric shock, do not hang the wall-mounted holder (6) in places where the hairdryer can fall into a bath or a sink.

Remove the back plate from the holder (6).
Mark out the places for drilling, drill the holes and insert plastic wall plugs. Fix the back plate with the screws.
Install the holder (6) on the back plate until the locks click.
Insert the hairdryer into the wall-mounted holder (6).

USING THE HAIRDRYER

Insert the power cord (8) plug into the main socket.
Take the hairdryer by the handle and remove it from the wall-mounted holder (6).
Use the switch (1) to set the required operation mode:
– «0» — the hot air styler is switched off;
– «1» — warm air supply;
– «2» — hot air supply.
The button (2) is the cool shot function « », press and hold down the «cool» shot button for fixing your hairstyle.
Note: during the first operation a foreign smell and a small amount of smoke can appear from the heating element, this is normal and it is not covered by warranty.
After the unit operation, switch the hairdryer off by setting the switch (1) to position «0», and insert the hairdryer into the wall-mounted holder (6).
Note: during the breaks between drying and styling your hair you can insert the hairdryer into the wall-mounted holder. The hairdryer will switch off. Remove the hairdryer from the holder (6), and the hairdryer will switch on in the preset operating mode.

NOZZLE

Use the nozzle (3) when you need to focus the power of drying on a small area (for example, a curl or a wave) or when you want to straighten wavy hair.
When the desired effect is achieved, press the cool shot button (2) « » and fix your hairstyle.

OVERHEATING PROTECTION

Overheating protection switches the hairdryer off if the outgoing air is too hot.
If the hot air styler is switched off during operation, set the switch (1) to the position «0», unplug the unit and make sure that the air inlets and outlets are unblocked.
Let the unit cool down for 5-10 minutes and switch it on again. Do not block the air inlets during the operation of the hot air styler and avoid getting hair into the air inlet grid (5).

CLEANING AND MAINTENANCE

Set the switch (1) to the «0» position and let it cool down.
Wipe the unit body (4) and the wall-mounted holder (6) with a slightly damp cloth, and then wipe it dry.
Do not immerse the unit in water or any other liquids.
Do not use abrasives and solvents to clean the nozzle (3), the unit body (4), and the wall-mounted holder (6).

STORAGE

Disconnect the unit from the mains and clean it.
Never mind the power cord around the hairdryer body (4), as it can lead to damage or damage to the unit body (4).
Keep the hairdryer on the holder (6) in a dry cool place out of reach of children and disabled persons.

DELIVERY SET

Hairdryer — 1 pc.
Nozzle — 1 pc.
Manual — 1 pc.

TECHNICAL SPECIFICATIONS

Supply voltage: 220-240 V, ~ 50-60 Hz
Rated input power: 2000 W

ATTENTION!
Do not use the unit near water in the bathrooms, showers, swimming pools, etc.

RECYCLING
To prevent possible damage to the environment or harm to the health of people by uncontrolled waste disposal, after the service life expiration of the unit or the batteries (if included), do not discard them with usual household waste, deliver the unit and the batteries to specialized centers for further recycling.

The waste generated during the disposal of the unit is subject to mandatory collection and consequent disposal in the prescribed manner.
For further information about recycling this product apply to a local municipal administration, a disposal service, or to the shop where you purchased this product.

The manufacturer reserves the right to change the appearance, design, and specifications not affecting the general operating principles of the unit, without prior notice.

The unit operating life is 3 years
The manufacturing date is specified in the serial number.
In case of any malfunctions promptly apply to the authorized service center.

BRAYER BR3210 Curling Tong - QR code RAYER is an Austrian consumer electronics brand. The importer in Russia – “Granted” LLC.
Hergestellt für «Ruste GmbH»,
Berggasse 18/18, 1090 Wien,
Osterreich
Produced for «Ruste GmbH»,
Berggasse 18/18, 1090 Vienna, Austria