ULINE H-5946 The Big Eight Table Installation Guide
- June 7, 2024
- ULINE
Table of Contents
ULINE H-5946 The Big Eight Table Installation Guide
TOOLS NEEDED
-
Rachet with 9/16″ Socket
-
Combination Wrench
-
Hammer
PARTS
-
Tabletop x 1
-
Seat x 4
-
L Bracket x 4
-
Legs x 8
-
X-Brace x 1
Hardware Kit x 1
-
2¼ Carriage Bolt x 16
-
2½” Hex Bolt x 12
-
3″ Hex Bolt x 4
-
Lock Washer x 32
-
Flat Washer x 24
-
Hex Nut x 32
ASSEMBLY
-
Push 2¼” carriage bolts through the predrilled holes of a seat. Use the hammer to set bolts firmly into place. (See Figure 1)
-
Attach two legs to the seat using a flat washer, lock washer, and hex nut on each bolt. It may help to position the seat upside down on an elevated surface. (See Figure 2) Repeat for the remaining three seats.
-
Attach a seat assembly to the X-brace using 2½” hex bolts. Secure using lock washers and hex nuts on the inside of the brace. The X-brace should be positioned with the holes on the top. Repeat on opposite side of the X-brace. (See Figure 3)
-
Attach an L bracket to the outside of each of the legs with the flange pointing towards the outside of the table using a 2½” hex bolt. Secure using a flat washer, lock washer and hex nut. (See Figure 4).
NOTE: The bolt should be positioned so that the bolt head is on the inside of the L bracket. -
With two people, lift and place the tabletop onto the legs with the support braces on the inside of the legs so that the predrilled holes are aligned with the holes in the L brackets. (See Figure 5)
-
Slide the remaining two leg assemblies into place on the insides of the tabletop support braces (See Figure 6).
-
Secure tops of legs to the tabletop and L brackets using a 3″ hex bolt secured with a flat washer, lock washer and hex nut. (See Figure 6)
-
Attach the bottoms of the legs to the X-Brace using 2½” hex bolts. Secure using a lock washer and hex nut.
Contact Us
Phone: 1-800-295-5510
Web: uline.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>