ULINE H-4114 Deluxe Mesh Task Chair Installation Guide
- June 7, 2024
- ULINE
Table of Contents
ULINE H-4114 Deluxe Mesh Task Chair
TOOL NEEDED
- Allen Wrench (included)
PARTS
Hardware Kit
ASSEMBLY
-
Insert casters into the legs of the five-star base. Turn the base upright. Insert gas lift into the center of the base. (See Figure 1)
-
Align the armrest with holes on the bottom of the seat cushion. Use one 1/4 x 1⁄” screw (8) and two 1/4 x 1⁄” screws (11) to attach. Repeat on the opposite side. (See Figure 2)
NOTE : Use an Allen wrench to tighten all screws -
Align mechanism with holes on the bottom of the seat cushion with tension knob facing the front of the seat. Use four 5/16 x 1″ screws (9) to attach. (See Figure 3)
-
Position back support in the slot between the bottom of the seat cushion and the mechanism. Align holes and use three 5/16 x 3/4″ screws (10) to attach back support to the mechanism. (See Figure 4)
-
Slowly lower the chair assembly onto the gas lift. Press down on the seat cushion to secure it in place. (See Figure 5)
CHAIR ADJUSTMENTS
- Seat Height Adjustment – To raise seat height, lift lever up with little to no weight on the seat. To lower seat height, lift lever up while sitting.
- Upright Tilt Lock – To lock chair in an upright position, push the lever in toward the center of the seat. To restore tilt, pull lever out. Chair has synchro-tilt; the back tilts at a two-to-one ratio to the seat angle.
- Tilt Tension – To increase tilt tension, turn knob clockwise. To decrease tilt tension, turn knob counterclockwise.
- Armrest Height Adjustment – To adjust arm height, press the button on the side of each armrest and move the armrest up or down
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>