ULINE H-2563 6′ A-Frame Picnic Table Installation Guide
- June 7, 2024
- ULINE
Table of Contents
H-2563 6′ A-FRAME PICNIC TABLE
TOOLS NEEDED
7/16″ (11 mm) Socket Bit
|
Phillips Head Drill Bit
---|---
Power Drill
|
Two Person Assembly (Optional)
PARTS
ASSEMBLY
| 
---|---
| 
NOTE: It is important to keep the lag screws loose throughout the
assembly. Tighten during step 8.
WARNING! Do not lean on tabletop or seats when assembling.
- Verify all parts are present before beginning.
- Place the two A-Frame bases on a flat level surface.
- Place one seat with a metal brace on each side of the A-Frame bases. Align the pre-drilled holes over the middle of the A-Frame base supports. The seat with a metal base should be flush with the end of the support.
- Loosely attach seats with a metal brace to A-Frame base with the 3/” lag screws and washers using the power drill and 7/16″ socket bit (will tighten later in step 8). (See Figure 1)
- Align the middle pre-drilled holes of tabletop boards to the tabletop support (different angle). Attach 31/2′ lag screws and washers using the power drill and 7/16′ socket bit. (See Figure 2)
- Place the three tabletop boards on the A-Frame bases. Align the pre-drilled holes with the A-Frame base. Loosely attach tabletop board slats to A-Frame base with the 3/” lag screws and washers using the power drill and 7/16″ socket bit (will tighten later in step 8). (See Figure 3)
- Loosely drill the two tabletop supports (equal angles) to the underside of the A-Frame table with the tabletop support (different angle) in the middle using 3″ deck screws (will tighten later in step 8). (See Figure 4)
- Make sure the table is square and tighten all lag and deck screws. NOTE: H-6681 Mounting hardware sold separately.
1-800-295-5510
uline.com
0721 IH-2563
H-2563
Documents / Resources
|
ULINE H-2563 6' A-Frame Picnic
Table
[pdf] Installation Guide
H-2563, 6 A-Frame Picnic Table
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>