ULINE H-6861, Big And Tall Mesh Chair Installation Guide
- June 7, 2024
- ULINE
Table of Contents
ULINE H-6861, Big And Tall Mesh Chair Installation Guide
TOOL NEEDED
Part
-
Back Support x 1
-
Seat Cushion x 1
-
5 star Base x 1
-
Caster x 5
-
Gas Lift x 1
-
Armrest x 2
-
Mechanism x 1
-
Screw x 4, 5/16 x 1
-
Screw x 8, 5/16 x 1 ¼
-
Screw x 4, 3/8 x 1 ½
-
Washer x 2
ASSEMBLY
-
Insert casters into legs of five-star base. Turn base upright. Insert gas lift into center of base. (See Figure 1)
-
Align armrest with holes on bottom of seat cushion. Use four 5/16 x 11/4″ screws (9) to attach. Repeat on opposite side. (See Figure 2)
NOTE: Use Allen wrench to tighten all screws.
-
Align mechanism with holes on bottom of seal cushion with tension knob facing the front of seat. Use four 5/16 x i• screws (8) to attach. (See Figure 3)
-
Align back support mounting plate with holes on bottom of seat cushion. Use two 3/8 x 11/2′ screws (10) to attach the mounting plate to the mechanism. Use two 3/8 x 1 ‘/2″ screws (1 0) with two washers (11) to attach the mounting plate directly to the seat cushion. (See Figure 4)
-
Slowly lower chair assembly onto the gas lift. Press down on seat cushion to secure n (See Figure 5)
CHAIR ADJUSTMENTS
-
Seat Height Adjustment – To raise seat height, lift lever up with little to no weight on the seat. To lower seat height, lift lever up while sitting.
-
Upright Tilt Lock – To lock the chair in an upright position, push the lever in toward the center of the seat. To restore tilt, pull lever out. Chair has standard tilt the seat and back tilt simultaneously at the same ratio.
-
Tilt Tension
To increase tilt tension, turn knob clockwise. To decrease tilt tension, turn knob counterclockwise. -
Armrest Height Adjustment – To adjust arm height, press the button on the side of each armrest and move the armrest up or down.
Website: uline.com
Contact: -800-295-5510
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>