ULINE H-4119 Foam Padded Mesh Chair Installation Guide
- June 7, 2024
- ULINE
Table of Contents
ULINE H-4119 Foam Padded Mesh Chair Installation Guide
1-800-295-5510
uline.com
TOOL NEEDED
Allen Wrench (included)
PARTS
ASSEMBLY
-
Insert casters into legs of five-star base. Turn base upright. Insert gas lift into center of base. (See Figure 1)
-
Align armrest with holes on bottom of seat cushion. Use one 1/4 x 1″ screw (8) and two 1/4 x 1 1/2″ screws (9) to attach. Repeat on opposite side. (See Figure 2)
NOTE: Use Allen wrench to tighten all screws.
-
Align mechanism with holes on bottom of seat cushion with tension knob facing the front of seat. Use four 5/16 x 3/4″ screws (10) to attach. (See Figure 3)
-
Align back cushion mounting plate with holes on bottom of seat cushion. Use four 5/16 x 1 1/4″ screws (11) to attach. (See Figure 4)
-
Slowly lower chair assembly onto the gas lift. Press down on seat cushion to secure in place. (See Figure 5)
CHAIR ADJUSTMENTS
- Seat Height Adjustment – To raise seat height, lift lever up with little to no weight on the seat. To lower seat height, lift lever up while sitting.
- Upright Tilt Lock – To lock chair in an upright position, push the lever in toward the center of the seat. To restore tilt, pull lever out. Chair has standard tilt; the seat and back tilt simultaneously at the same ratio.
- Adjustable Lumbar Support – To adjust lumbar support, lift support bar up or down to desired height using both hands.
- Tilt Tension – To increase tilt tension, turn knob clockwise. To decrease tilt tension, turn knob counterclockwise.
- Armrest Height Adjustment – To adjust arm height, press the button on the inside of each armrest and move the armrest up or down.
uline.com
Documents / Resources
|
ULINE H-4119 Foam Padded Mesh
Chair
[pdf] Installation Guide
H-4119, Foam Padded Mesh Chair
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>