ULINE H-2564 8′ A-FRAME Picnic Table Installation Guide
- June 7, 2024
- ULINE
Table of Contents
H-2564
8′ A-FRAME PICNIC TABLE
1-800-295-5510
uline.com
Two person assembly (optional)
PARTS
ASSEMBLY
NOTE: It is important to keep the lag screws loose throughout the
assembly. Tighten during step 6.
WARNING! Do not lean on tabletop or seats when assembling.
- Verify all parts are present before beginning.
- Place the three A-Frame bases on a flat, level surface.
- Place one seat board on each side of the A-Frame bases. Align the pre-drilled holes over the middle of the A-Frame base supports. The seat board should be flush with the end of support.
- Loosely attach seat boards to the A-Frame base with the 31/2″ lag screws and washers using the power drill and 7/16″ socket bit (will tighten later in step 6). (See Figure 1)
- Place the three tabletop boards on the A-Frame bases. Align the pre-drilled holes with the A-Frame base. Loosely attach tabletop board slats to A-Frame base with the 31/2″ lag screws and washers using the power drill and 7/16″ socket bit (will tighten later in step 6). (See Figure 2)
- Make sure the table is square and tighten all lag screws.
ASSEMBLY CONTINUED
- Attach leg brace board to the underside of the A-Frame bases with the TA” lag screws and washers using the power drill. (See Figure 3) ,—,
**NOTE: H-6681 Mounting hardware sold separately.
**
H-2564
1-800-295-5510
uline.com
0721 IH-2564
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>