ULINE Steel Disk Single Pedestal User Guide
- June 7, 2024
- ULINE
Table of Contents
H-7829
STEEL DESK SINGLE PEDESTAL
1-800-295-5510
uline.com
TOOL NEEDED
Phillips Screwdriver
Two Person Assembly Recommended
PARTS
ASSEMBLY
NOTE: Use Phillips screwdriver to tighten screws.
NOTE: Assemble on smooth, non-marring surface to avoid scratching.
NOTE: Check that all parts are included.
WARNING! Take care when handling metal parts. Sharp edges may cause
injury.
-
Lock drawers. With two people, turn desk upside down.
-
Place open end of leg over alignment peg on bottom of desktop at corner. (See Figure 1)
-
Insert one leg bracket into the corresponding slot in leg. (See Figure 2)
NOTE: Bracket may flip up or down, depending on which leg user is installing.
-
Align leg bracket with holes in pedestal file. Use two #8 x 1/2″ screws to secure. Repeat for remaining legs. (See Figure 3)
-
With two people, set desk upright and position in desired location. Adjust leveling glides as needed.
-
Place drawer divider at desired location in top drawer and insert grommet into desktop.
0721 IH-7829
Documents / Resources
|
ULINE Steel Disk Single
Pedestal
[pdf] User Guide
Steel Disk Single Pedestal, H-7829
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>