ULINE Wire Security Room Sliding Door Installation Guide
- June 7, 2024
- ULINE
Table of Contents
WIRE SECURITY ROOM -SLIDING DOOR
TOOLS NEEDED
PARTS
INSTALLATION
Prior to installation, read instructions all the way through and determine
room placement.
NOTE: Be sure to include the additional width of the posts and mounting
plate dimensions when determining placement.
MOUNTING THE POSTS
- Verify that the first post is positioned in the desired location. Mark the floor where the holes will be drilled.
- Using a 3/8″ masonry drill bit, drill a hole approximately 3″ deep into the floor. (See Figure 1)
- Clean out debris and dust from inside the hole, and fully insert anchor bolt through the mounting plate and into the hole.
- Tap down the anchor bolt with a hammer. Slide a washer onto the anchor bolt. Using a 17 mm wrench, tighten the hex nut until the anchor bolt is secure. Repeat for the remaining anchor.
ATTACHING PANELS TO POSTS
-
For a straight run, end to end, use straight bolts and flat washers. (See Figure 2) Use a 13 mm wrench to tighten.
NOTE: Safe installation requires two people. -
For a 90° corner, use curved bolts and lock washers. (See Figure 3)
-
Attach the opposite end of the panel to the second post.
ATTACHING SLIDING DOOR TO POSTS
-
Using straight bolts, washers and nuts, install upper door track onto posts. Door track installs on top hole of the post. (See Figure 4)
-
Insert and attach trolley assembly to the top of the door. (See Figure 5)
-
Slide the assembled door into the upper door track. (See Figure 6)
-
Mount floor door track using concrete anchors. (See Figure 7)
-
Attach latch receiver and bottom door slam using self-tapping screws. (See Figure 8)
NOTE: Use a screw gun with an adjustable clutch, and take care not to over tighten and strip the threads. DO NOT USE IMPACT-TYPE GUNS.
NOTE: Holes are not pre-drilled. Apply pressure with self-tapping screws to puncture the post. -
Mount door stopper to opposite/receiving post. (See Figure 9)
-
Attach handle to door using the provided handle and bolts. (See Figure 10)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>