ULINE 66 X 72″ Steel L-Desk Instructions
- June 7, 2024
- ULINE
Table of Contents
ULINE 66 X 72″ Steel L-Desk
PARTS
ASSEMBLY
NOTE: Use Phillips screwdriver to tighten screws.
NOTE: Assemble on smooth, non-marring surface to avoid scratching.
NOTE: Check that all parts are included.
WARNING! Take care when handling metal parts. Sharp edges may cause
injury.
-
Lock drawers. With two people, turn pedestal desk upside down.
-
Place open end of leg over alignment peg on bottom of desktop at corner. (See Figure 1)
-
Insert one leg bracket into corresponding slot in leg. (See Figure 2)
NOTE: Bracket may flip up or down, depending on which leg user is installing.
-
Align leg bracket with holes in pedestal file. Use two #8 x 1/2″ screws to secure. Repeat for remaining legs. (See Figure 3)
-
With two people, set desk upright and position in desired location.
-
With two people, turn return desk upside down.
-
Follow steps 2-4 to install remaining legs.
-
Remove filler block and discard. (See Figure 4)
NOTE: Keep filler block screws for next step.
-
With two people, set return desk upright and position with top connector plate under assembled 30 x 66″ pedestal desk. Align holes and use five #8 x 3/4″ screws to secure. (See Figure 5).
-
Align bottom connector plate with holes in pedestal desk and return desk. Use two #8 x 1/2″ screws and one #8 x 1/4″ screw to secure. (See Figure 6)
NOTE: Remove #8 x 1/4″ screw from bottom connector plate before you install it. Once bottom connector plate is aligned, use same #8 x 1/4″ screw to secure plate.
-
Adjust floor glides to compensate for uneven floors.
-
Place drawer dividers at desired locations in top drawers and insert grommets into desktop.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>