Razor C25 & C25 SLA Charger Port Replacement Instruction Manual
- June 7, 2024
- Razor
Table of Contents
Razor C25 & C25 SLA Charger Port Replacement
Required Tools: (Not included)
A. Phillips screwdriver
B. Flat screwdriver
C. 17 mm wrench
D. Needle nose pliers
WARNING
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before conducting any assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.
HOW TO USE:
Step 1
Using a Phillips screwdriver, remove six (6) screws from the deck. Remove the deck from the unit and set aside.
Step 2
Locate and disconnect the battery connector from the controller.
Step 3
Disconnect the charger port from the controller.
Step 4
Using a flat screwdriver remove the plastic glue at the back of the charger
port.
Step 5
Using a 17 mm wrench or long needle nose pliers loosen band remove the lock
nut from the charger port and pull the charger port from outside the
unit.
Step 6
Reverse the steps: Reposition the deck and attach with the screws that were removed in Step 1.
ATTENTION: Charge battery 8 hours before using.
Need Help? Visit our website at www.razor.com or
call toll-free at 866-467-2967 Monday –
Friday 8:00am – 5:00pm Pacific Time.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>