Razor W15128099022 Bulletin Rambler 16 Foot Pegs Replacement Instructions
- June 3, 2024
- Razor
Table of Contents
Bulletin Rambler 16 Foot Pegs
Replacement Instructions
Rambler 16 Foot Pegs Replacement
Required Tools: (Not included)
A. Two (2) 5 mm Allen wrenches
WARNING
CAUTION: To avoid potential shock or other injury, turn power switch OFF and
disconnect charger before conducting any assembly or maintenance procedures.
Failure to ollow these steps in the correct order may cause irreparable
damage.
Step 1
Using two (2) 5 mm Allen wrenches, loosen the coupling bolt and remove it.
Step 2
Make sure to place your thumb or hand on the side to prevent the ball bearing
from jumping away as you slide the foot peg out from the frame.
Step 3
When installing the new foot pegs, make sure to insert the spring and then the
ball bearing in place.
Step 4
The side of the foot peg with the spring and ball bearing needs to face the
side with the three (3) holes on the frame.
Step 5
Reverse the steps.
ATTENTION: Charge battery 12 hours before using.
Need Help?
Visit our website at www.razor.com or
call toll-free at 866-467-2967
Monday – Friday 8:00am – 5:00pm Pacific Time
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>