RAZOR GGC2228MC Universal Cart for Potable Griddles Owner’s Manual

RAZOR GGC2228MC Universal Cart for Potable Griddles

WARNING
FOR YOUR SAFETY DO NOT LEAVE THIS APPLIANCE UNATTENDED WHILE IN USE, ESPECIALLY COOKING THE FATTY MEAT AND CLOSE THE LID TOO LONG TIME

WARNING
FOR YOUR SAFETY For Outdoor Use Only! (outside any enclosure)

IMPORTANT
After each use, always season your griddle per “Seasoning Griddle” section.

SAFETY INSTRUCTIONS

DANGER : Failure to follow the dangers, warnings and cautions in this manual may result in serious bodily injury or death, or in a fire or an explosion causing damage to property.

WARNINGS

• For residential use only. This griddle cart is NOT for commercial use.
• This griddle cart is safety certified for use in the United States and/or Canada only. Do NOT modify for use in any other location. Modification will result in a safety hazard and will void your warranty.
• Inspect this griddle cart before each use.
• Do NOT alter griddle cart in any manner. Any alteration will void your warranty.
• Do NOT use the griddle cart unless it is COMPLETELY assembled and all parts are securely fastened and tightened.
• Do NOT build this model of griddle cart in any built-in or slide-in construction. Ignoring this warning could cause a fire or an explosion that can damage property and cause serious bodily injury or death.
• Exercise reasonable care when operating your griddle cart.
• Place the griddle cart on an outdoor stable level surface before placing the oven & grill on the cart.
• Never set up the griddle cart on a sloping surface.
• The griddle cart is meant for the use of the grill only. Do NOT attempt to attach any other products or appliances to the griddle cart.
• Remove the griddle from the griddle cart before placing the griddle cart in a vehicle trunk, station wagon, mini-van, sport utility vehicle (SUV), recreational vehicle (RV), or any storage area.
• NEVER use the griddle cart as a step stool or ladder or climb on the griddle cart.
• Do NOT use the griddle cart or place the griddle on the grilddle cart if any parts are missing or damaged.
• This griddle cart should be thoroughly cleaned and inspected on a regular basis.
• Clean and inspect before each use of the griddle cart. If there is evidence of abrasion, wear, cuts or breaks, fix or replace prior to operation.
• Use only RevoAce Inc. Limited. factory-authorized parts. The use of any part that is not factory-authorized can be dangerous and will void your warranty.
• Do NOT operate griddle cart without reading “Operating Instructions” in this manual.
• Do NOT attempt to move griddle when in use. Allow the griddle cart to cool before moving or storing.
• Always place your griddle cart on a hard, non-combustible, level surface. An asphalt or blacktop surface may not be acceptable for this purpose.
• Use protective gloves when assembling this product.
• Do NOT force parts together as this can result in personal injury or damage to the product.
• Death, serious injury or damage to property may occur if the above is not followed exactly.

1 **** Cart Table        G2228-100

|
2 ** Left Side Shelf        G2228-110
3 ** Side Cart Handle        G2228-120
4 ** Drawer        G2228-130
5 ** Upper Back Panel        G2228-140
6 ** Left Table (2)        G2228-150
7 ** Back Panel        G2228-160
8 ** Right Table        G2228-170
9 ** Left Cart Frame        G2228-180
10 ** Center Panel         G2228-190
11 ** LP Gas Tank Retainer

Wire                                     G1461-010

12 ** Axle         G2228-200
13 ** Wheel (2)         B0340-010
14 ** Wheel Cap (2)         B0340-020
15 ** Right Cart Frame         G2228-210
16 ** Door         G2228-220
17 ** Foot (2)         C1681-000
18 ** Bottom Panel         G2228-230
19 ** Spacer*(8)         G2228-240
20 **** Paper Towel Holder         G2228-260

Support

21 ** Magnet (2)         B0303-010
22 ** Drawer Support (2)         G2228-270
23 ** Bottle Opener         G1932-11L
24 ** Paper Towel Holder         G2228-160

• Pre-assembled

Hardware

1. A Screw M6x15 Nickel Plated Phillips Truss Head 24 pcs
2. B Nut M4x12 Nickel Plated Phillips Truss Head 16 pcs
3. C Washer Φ 6.5×13 Nickel Plated 4 pcs
4. D Lock Washer Φ 6.5 Nickel Plated Phillips Truss Head 4 pcs
5. E Screw M6x15 Nickel Plated Hex Head 4 pcs
6. F Nut M10 Zinc Plated Hex 2 pcs
7. G Cotter Pin Φ 1.4X38 Nickel Plated Phillips T russ Head 2 pcs
8. H Screw M6x15 Axial Truss Head 2 pcs

Tools Required for Assembly Included

Assembly Instructions

DO NOT RETURN TO PLACE OF PURCHASE. For assistance, call 1.800.694.0013 toll- free. Please have your owner’s manual and model number available for reference.

Assembly Tips:

1. Select an area where you will assemble this product. To protect components, choose a smooth surface that’s free of cracks or openings.

2. Spread out all parts.

3. Tighten all hardware connections by hand first. Then, before completing each step, go back and fully tighten all hardware. Be careful not to over-tighten. That could damage surfaces or strip threads.

4. For best results, complete each step in the order presented.
   After assembly you will need:

5. (1) Leak Detection Solution (instructions on how to make solution are included in “Operating Instructions” section).

6. (1) 14.1 oz or (1) 16.4 oz LP gas tank (not included). Typical assembly is approximately 30 minutes.

7. Attach Drawer Support onto Left Cart Frame

8. Attach Bottom Panel

9. Attach Lower Back Panel

10. Attach Upper Back Panel

11. Attach Legs

12. Attach Drawer Support onto Center Panel

13. Attach Center Panel

14. Attach Left Table-Lower

15. Attach Left Table-Upper

16. Attach Magnet

17. Attach LP Gas Tank Retainer Wire

18. Attach Magnet

19. Attach Cart Table

20. Attach Right Table

21. Attach Bottle Opener and Side Cart Handle

22. Attach Left Side Shelf
    Note : Leave 5 mm of bolt threads exposed

23. Attach Screws onto Left Side Shelf and Insert Drawer

24. Attach Door

25. Attach Paper Towel Holder Support

26. Attach Paper Towel Holder
    Note : Remove the cotter pins from the paper towel holder first and then attach the paper towel holder onto the paper towel holder support with the cotter pins

Installing LP Gas Tank

To operate, you will need one precision-filled standard barbecue grill LP gas tank with external valve threads.

• CAUTION : LP gas tank must be properly disconnected and removed prior to moving this griddle.
• Caution : Always place your griddle on a hard, non-combustible, level surface. An asphalt or blacktop surface may not be acceptable for this purpose.
• Caution : Move gas hoses as far away as possible from hot surfaces and dripping hot grease.
• Caution : The gas hose should be arranged so that it will not be pulled on or tripped over.

Inserting LP Gas Tank
Place precision-filled LP gas tank upright into the notches in the right cart frame so the tank valve is facing the gas line connection.

Securing LP Gas Tank

Connecting LP Gas Tank

1. Before connecting, be sure there is no debris caught in the head of the LP gas tank, head of the regulator valve or in the head of the burner or burner ports..
2. Connect regulator/hose assembly to tank by turning knob clockwise until it stops.

Disconnecting LP Gas Tank

1. Before disconnecting, make sure the LP gas tank valve is “CLOSED.”

2. Disconnect regulator/hose assembly from LP gas tank by turning knob counterclockwise until it is loose.

3. Disconnect regulator/hose assembly from LP gas tank by turning knob counterclockwise until it is loose.
   CAUTION : LP gas tank must be properly disconnected and removed prior to moving this griddle.

4. Place the protective cap cover on the LP tank and store the tank outdoors in a well ventilated area out of direct sunlight

Operating Instructions

Follow all instructions in the Portable LP Gas Griddle owner’s manual.

Cleaning and Care

Follow all instructions in the Portable LP Gas Griddle owner’s manual.

Product Registration

For faster warranty service, please register your product immediately. To register, call 1.800.694.0013.

Replacement Parts

For replacement parts, call 1.800.694.0013.

Limited Warranty

RevoAce Inc. Limited (“manufacturer”) warrants to the original retail purchaser of this product, and to no other person, that if this product is assembled, maintained, and operated in accordance with the printed instructions accompanying it, then for a period of one (1) year from the date of purchase, all parts in such product shall be free from defects in material and workmanship. Manufacturer may require reasonable proof of your date of purchase. Therefore, you should retain your sales slip or invoice. This Limited Warranty shall be limited to the repair or replacement of parts, which prove defective under normal use and service and which manufacturer shall determine in its reasonable discretion upon examination to be defective. Before returning any parts, you should contact manufacturer’s Customer Service Department using the contact information listed below. If manufacturer confirms, after examination, a defect covered by this Limited Warranty in any returned part, and if manufacturer approves the claim, manufacturer will replace such defective part without charge. If you return defective parts, transportation charges must be prepaid by you. manufacturer will return replacement parts to the original retail purchaser, freight or postage prepaid. This Limited Warranty does not cover any failures or operating difficulties due to accident, abuse, misuse, alteration, misapplication, improper installation or improper maintenance or service by you or any third party, or failure to perform normal and routine maintenance on the product as set out in this owner’s manual. In addition, the Limited Warranty does not cover damage to the finish, such as scratches, dents, discoloration, rust or other weather damage, after purchase. This Limited Warranty is in lieu of all other express warranties. manufacturer disclaims all warranties for products that are purchased from sellers other than authorized retailers or distributors, including the warranty of merchantability or the warranty of fitness for a particular purpose. MANUFACTURER ALSO DISCLAIMS ANY AN

RevoAce Inc. Limited Hong Kong, China

• service@revoace.com
• 1.800.694.0013

8:00 am to 4:00 pm central time, Monday to Friday.

Manufactured in China for : RevoAce Inc. Limited Hong Kong, China 1.800.694.0013 service@revoace.com 8:00 am to 4:00 pm central time, Monday to Friday.

© RevoAce Inc. Limited
Razor® is a registered trademark of Mr. Bar-B-Q Products LLC. Used with permission. GriddleOnTM is a trademark of Mr. Bar-B-Q Products LLC. Used with permission. Make it SizzleTM is a trademark of Mr. Bar-B-Q Products LLC. Used with permission.

References

• Griddle | Razor Griddle Grill | Razor Griddle

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>