Razor C25 & C25 SLA Rear Fender Replacement Instruction Manual
- June 7, 2024
- Razor
Table of Contents
Razor C25 & C25 SLA Rear Fender Replacement
Required Tools: (Not included)
A. Phillips screwdriver
B. 5 mm Allen wrench
C. 10 mm wrench
WARNING:
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before conducting any assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.
Step 1
Using a Phillips screwdriver, remove six (6) screws from the deck. Remove the
deck from the unit and set aside.
Step 2
Locate and disconnect two (2) rear fender connectors.
Step 3
Using a size 5 mm Allen wrench and a 10 mm wrench remove the lock nut and bolt
that holds the rear fender onto the frame.
Step 4
Using a Phillips screwdriver, remove two (2) screws that hold the brake sensor
onto the frame. Remove brake sensor and set aside.
Step 5
Reverse the steps.
Reposition the deck and attach with the screws that were removed in Step 1.
ATTENTION: Charge battery 8 hours before using.
Need Help? Visit our website at www.razor.com or
call toll-free at 866-467-2967 Monday –
Friday 8:00am – 5:00pm Pacific Time.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>