ULINE Basket Truck Replacement Liner Installation Guide
- June 7, 2024
- ULINE
Table of Contents
ULINE Basket Truck Replacement Liner
TOOL NEEDED
Utility Knife
Industrial scissors may be used.
ASSEMBLY
LINER REMOVAL
(IF LINER IS RIVETED TO FRAME)
- Using a utility knife, start by slicing the liner casing (from top to bottom) around each corner and frame rod. Make sure the liner is completely detached from the frame rods.
- Cut completely around the top of the black hem of the liner above the rivets (be sure to cut through all layers).
- Cut the liner around each of the metal rivets.
- Cut through any remaining material to remove the liner from the basket truck frame.
LINER INSTALLATION
-
Remove the replacement liner and rope from poly bag.
-
Unfold the liner and insert into frame. When inserting the liner, be sure:
• The black hem is facing inward.
• The Uline pocket is facing outward on the narrow end of the basket truck. NOTE: 6 and 24 BU basket truck pocket is positioned in the center.
NOTE: 10 through 20 BU basket truck pocket is positioned on the right side of the center frame rod.
-
Fold the black hem over the frame so the grommets are aligned on the inside and outside.
-
On a narrow end of the truck, begin threading the rope from the center grommets. Start threading from the outside to the inside. Continue outward from the center.
-
As you approach the corners, thread the rope from the inside to the outside. The rope should go around the corners on the outside.
-
Continue around the perimeter. You should end with both ends of the rope on the outside.
-
Pull the rope around the basket truck as tight as possible. Tie the two ends using a double knot. Trim the rope as necessary.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>