SEPURA Status Indicator Lights User Guide
- September 6, 2024
- sepura
Table of Contents
Status Indicator Lights
Regular Use
Bin Capacity
White lights indicate how full the bin is inside the Collection Center.
Booting Up
Booting
While Sepura is booting, a light animation will display in blue, green, pink and white.
Creating Access Point
While Sepura is creating its Wi-Fi hotspot, lights will progressively light up green.
Access Point is Live
Once the Sepura-Home hotspot is created, lights will slowly blink green.
Successfully Connected to Home Wi-Fi
After connecting Sepura to your home’s Wi-Fi, lights will
flash green twice when successful.
Warnings
Bin Too Full
Lights will flash white when the bin inside the Collection Center is full.
Stuck
If Sepura gets stuck, lights will flash blue until you safely remove the object obstructing it.
Flooded
If sink is fult of water, lights will flash yellow until Sepura is free to run again.
Something Went Wrong
If lights are blinking red, factory reset Sepura by pressing the button for 20 seconds or until 4 purple lights appear, then release the button.
Software Update
Long Press (10 seconds)
Press and hold button until two purple lights appear to start the over-the-air update.
Connecting to Wi-Fi
Lights will progressively light up green as Sepura connects to your home Wi- Fi.
Updating
While Sepura is undergoing an over the air update, lights will breathe white.
Update Successful
Once Sepura has updated successfully, lights will flash white.
Bin Calibration
Extra Long Press (15 seconds)
Press and hold button until three purple lights appear to start calibration.
Calibrating
While the Collection Center is calibration, lights will progressively light up white.
Calibration Successful
Once calibration is successful, the first light will flash white.
Factory Reset
Extra Long Press (20 seconds)
Press and hold button until four purple lights appear to factory reset your Sepura.
Status Indicator Lights
sepurahome.com