sternglas Naos Automatik Watch User Manual
- June 5, 2024
- sternglas
Table of Contents
sternglas Naos Automatik Watch
OVERVIEW
How to setup your timepiece
- Before you can start, you need to wind up your timepiece. To do so, wind the crown (in position 1) clockwise about 15 times. If you notice a slight whirring sound, the movement starts working.
- Now you are ready to set the time. To do so, pull the crown to position 3 and turn until the hands are in the correct position.
- To set the date, push the crown in by one position so that it is in position 2. Turn the crown clockwise until the correct date is displayed. Now you can push the crown back to the starting position (position 1).
Note: Your date changes at noon? This is because the movement does not „know” if it is noon or midnight. If so, simply wind your timepiece forward by 12 hours.
You would rather have a different strap on your timepiece? No problem, changing it couldn‘t be easier.
- On the back of your strap, you will find a small metal pin. Slide this inward.
- The band can then be easily detached from the watch case.
- Now you can attach a new strap to your timepiece. To do so, do the same thing again: push back the metal pin and then release it to let the new strap snap into place. Make sure you attach the short side to the upper side of the watch. Final check: Is everything securely in place? Done.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>