ULINE Pegboard Installation Guide

June 7, 2024
ULINE

ULINE Pegboard Installation Guide

ULINE Pegboard Installation Guide

SAFETY

  • ALWAYS wear safety glasses when using any power tool.
  • ALWAYS use hearing protection when using loud equipment.
  • DO NOT sit, climb, hang or step on hooks or holders.
  • DO NOT overload hooks or holders.
  • DO NOT try to install pegboard panels by yourself. Use two people.

INFORMATION

SUGGESTED TOOLS

  • 24″ Level
  • Tape Measure
  • Pencil
  • Chalk Line
  • Drill with Phillips Screwdriver Attachment
  • Glue

SUPPLIES

8 wood screws, 11/2″ to 2″, with anchors and 1/2″ tall spacers.

GENERAL

  1. Install over studs, plaster, furring strips or drywall.

  2. Snap chalk line at desired height on wall.
    NOTE : Screws may not always anchor into a stud.

  3. Mark all holes on wall before hanging pegboard.
    NOTE : If hanging multiple pegboards, mark ALL holes first.

INSTALLATION

INSTALLATION DIAGRAM

1. Screw
2. Pegboard
3. Spacer
4. Wall
5. Anchor

ULINE Pegboard Installation - DIAGRAM

PREPARATION

  1. With someone holding the pegboard in place, mark all holes on wall according to Figure 1 below where screws will be inserted for hanging. (See Figure 1)

  2. Pre-drill holes in wall if using anchors.
    NOTE : Use a 3/16″ drill bit.

  3. Insert anchors into holes in wall.

  4. Following Figure 1 below, glue spacers to back of all pegboard holes through which screws will be inserted. Be careful to glue spacers over the same pegboard holes used to mark wall in step 1 or spacers and holes in wall will not line up correctly. (See Figure 1)

ULINE Pegboard Installation - Fig. 1

HANGING PEGBOARD (See Figure 1)

NOTE : Follow this order for best results. Do not fully tighten screws until all 21 are in place.

  1. Fasten 3 top screws (A).
    • 3rd row from top, 33rd, 48th column from left, and 34th column from right.
  2. Fasten 3 center screws (B).
    • 24th row from top, 33rd, 48th column from left, and 34th column from right.
  3. Fasten 4 inner side screws (C).
    • 3rd row from top, 17th column from left and 18th column from right.
    • 24th row from top, 17th column from left and 18th column from right.
  4. Fasten 4 outer side screws (D).
    • 3rd row from the top, 2nd column from the left and 2nd column from the right.
    • 24th row from the top, 2nd column from the left and 2nd column from the right.
  5. Fasten 7 bottom screws (E).
    • 3rd row from the bottom, 2nd column from the left and 2nd column from the right.
    • 3rd row from the bottom, 17th column from the left and 18th column from the right.
    • 3rd row from the bottom, 33rd, 48th column from the left, and 34th column from right.

1-800-295-5510
uline.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals