ULINE Stainless Steel Worktable Installation Guide

June 7, 2024
ULINE

ULINE Stainless Steel Worktable Installation Guide
ULINE Stainless Steel Worktable
ULINE Logo

TOOL NEEDED

  • 5/32 Allen Wrench (included)
    Allen Wrench \(included\)

PARTS

  1. Tabletop x 1 (H-6259, H-6260, H-6261 include back splash)
    Parts List

  2. Under shelf x 1
    Parts List

  3. Legs with Adjustable Feet x 4 (x 6 for H-5345 and H-5691)

  4. Set Screw x 8 (x 12 for H-5345 and H-5691)

  5. Caster x 4 (Optional ) (x 6 for H-5345 and H-5691)
    Parts List

ASSEMBLY

NOTE: If purchased with optional casters, adjustable feet will be replaced after complete table assembly

  1. With the undershelf on its side, push the legs through the collars to the desired To ensure exact height, mark desired height on each leg with magic marker or grease pencil. (See Figure 1)
    Assembly Instructions
    NOTE:
    Each leg must be at the same height or shelf collars could fail. Recommended height from the floor to the top of the undershelf is 10″ and must be 6″ or higher to meet NSF standards
    NOTE: Optional casters add 3¾” to height.

  2. Secure legs to undershelf with set screws using 5/32 Allen wrench. (See Figure 2)
    Assembly Instructions
    NOTE:
    Undershelf must be level. Use care not to overtighten screws or failure will occur.

  3. Stand table upright and place tabletop onto legs, inserting legs into tabletop gussets. With a 5/32 Allen wrench, tighten set screw on each gusset. (See Figure 3)
    Assembly Instructions

  4. Level table with the adjustable Adjustable feet allow approximately 1 of adjustment. (See Figure 4)
    Assembly Instructions

OPTIONAL CASTERS

  1. Flip the table back over onto a smooth, non-marring surface. Remove adjustable feet from tube legs using a flat head screwdriver . (See Figure 6)
    OPTIONAL CASTERS
    NOTE:
    You may need to use a rubber mallet or hammer to assist.

  2. Hold caster base and rotate nylon bushing clockwise. This will cause the rubber piece to expand. (See Figure 7)
    OPTIONAL CASTERS

  3. Expand the rubber enough so that it will fit snugly into the tube

  4. With caster fully inserted into the leg, turn clockwise until caster is secured to tube leg. **(See Figure 8)

NOTE: **If too loose, pull out caster and tighten further. Repeat step 2.

Contact Us

Phone: 1-800-295-5510
Web: uline.com

ULINE Logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals