ULINE 48′ Round Conference Table Instructions

June 7, 2024
ULINE

ULINE 48′ Round Conference Table Instructions
ULINE 48' Round Conference Table

TOOLS NEEDED

  • Phillips Screwdriver
    Screwdriver

  • Drill (Optional)

  • Two Person Assembly Required

PARTS

  • Camlock Pin x 10

  • Camlock x 10

  • **Dowel x 3

**

  • Floor Glide x 4

  • L-Bracket x 4
    L-Bracket

  • Screw x 29 #4 5/8″

  • Deep Camlock Cap x 10
    Deep Camlock

ASSEMBLY

NOTE: Assemble on a smooth, non-marring surface to avoid scratching the table.

  • Check that all parts are included.

IMPORTANT: The arrow on the camlock (B) must point toward the camlock pin (A) for proper alignment. Turn camlock (B) clockwise until it locks with pin (A
Function of cam

  1. Insert four camlocks (B) into holes on leg panel (2). Insert four camlock pins (A) and two dowels (C) in center leg (1). Fit center leg (1) and leg panel (2) together and turn each camlock (B) clockwise until it locks. Cover each camlock (B) with a deep camlock cap (G). (See Figure 1)

  2. Repeat to attach leg panel (3) to center leg (1). (See Figure 1)
    Assembly Instruction

  3. Place tabletop (4) upside down on a smooth, non-marring surface. Insert four camlocks (B) into corresponding holes on leg panels (1, 2 and 3). Insert four camlock pins (A). With two people, place the assembled base on the tabletop (4). Turn each camlock (B) clockwise until it locks. Cover each camlock (B) with a deep camlock cap (G). (See Figure 2).

  4. Attach an L-Bracket (E) to each side of the center leg (1) and secure to tabletop (4) using four #4 5/8″ screws (F) per bracket. Tighten screws with Phillips screwdriver. (See Figure 3)

  5. Attach an L-Bracket (E) to leg panel (2) and secure to tabletop (4) using four #4 5/8″ screws (F). Tighten screws with Phillips screwdriver. Repeat to attach leg panel (3) to tabletop (4). (See Figure 3)
    Assembly Instruction
    NOTE: Ensure two L-Brackets connect center leg (1) to the tabletop (4) and one L-Bracket connects each leg panel (2 and 3) to the tabletop (4).
    NOTE: L-Bracket holes can be started with drill (optional).

  6. Mount floor glides (D) on center leg (1), and leg panels (2 and 3). Floor glides (D) can be adjusted to compensate for uneven floors. (See Figure 4)
    Assembly Instruction

  7. With two people, turn table over and set it upright. (See Figure 5)

Contact: 1-800-295-5510

Website: uline.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals