ULINE Edge Protector Cutter Instructions

Table of Contents

Flathead Screwdriver Allen Wrench (included) Magnet (included)

WARNING! Cutter contains sharp blade. Read operating instructions before using. Use extreme caution during operation.

NOTE: This unit cuts 90º paper edge protectors up to 3 x 3″, 0.225″ thick.

NOTE: Before using, turn handle to correct position.

Loosen screws with flathead screwdriver and Allen wrench. Turn handle 180° and re-tighten screws. (See Figure 1)

Figure 1
Press handle down and pull safety pin out. Now, tool is ready for use. (See Figure 2)
NOTE: Keep safety pin in holder.

**_ OPERATION CONTINUED

Insert edge protector into slot with handle up. Firmly press handle down to cut to desired length. (See Figure 3)

Figure 3
NOTE: You may use the newly cut edge protector as a template to cut necessary length for additional protectors. (See Figure 4)

Figure 4
When done cutting, press the handle down and insert safety pin to lock handle movement. (See Figures 5-6)
NOTE: Ensure pin protrudes through back side of cutter. This indicates pin is fully inserted.

_ **Figure 5

Figure 6**_

Insertion of safety pin locks movement of handle.
NOTE: With unit locked, you may carry cutter by handle.
NOTE: For safety reasons, always lock handle when not in use.

Figure 7

Replace dull blades to ensure best cut quality.
Clean tool with brush and periodically use clean, compressed air to blow dust off of unit.
Regularly apply light machine oil to all moving parts.

WARNING! Not following instructions may cause injury to user.

Remove four screws and pull protective shield out. (See Figure 8)

Figure 8
Lift handle approximately 60° up to allow insertion of safety pin into hole. (See Figure 9)

Figure 9
After insertion of pin, confirm safety pin protrudes through other side. (See Figure 10)
NOTE: The safety pin now blocks the movement of handle.

Figure 10
Put tool down to horizontal position. Use Allen wrench to free screws and washers. Remove two cutter blocks. (See Figure 11)

Figure 11

For safety reasons, use included magnet to hold new blade. (See Figure 12)

Figure 12
Using magnet, place blade against pins as shown. (See Figure 13)

Figure 13

Put cutter blocks back. Fasten two screws and washers. Repeat previous steps for blade on opposite side. (See Figure 14)

Figure 14
Press handle down, and while at this position, pull safety pin out. Place safety pin into pin holder. Replace protective shield as shown. Tighten four screws. Cutter is ready for use. (See Figure 15)

Figure 15

WARNING! Not following instructions may cause injury to user.

Loosen screws. Remove protective shields on both sides. (See Figure 16)

Figure 16
Lift handle approximately 60° up to allow insertion of safety pin into hole. (See Figure 17)

Figure 17
After insertion of pin, confirm safety pin protrudes through other side. (See Figure 18)
NOTE: The safety pin now blocks the movement of handle.

Figure 18
Unscrew bolts, nuts, block plates and fixed plate. (See Figure 18)

Two numbers are marked on cutting board: “1” on one side and “2” on the other. Flip cutting board to opposite side, as both sides may be used before replacement. If both sides have been used, replace
cutting board. Then, tighten fixed plate, block plates, bolts and nuts. (See Figure 19)

Figure 19
Pull safety pin out. (See Figure 20)

Figure 20
Put handle down. Re-install protective shield. Replace and tighten all screws. (See Figure 21)