ULINE Tightener Cutter H-348 Instructions
- June 7, 2024
- ULINE
Table of Contents
ULINE Tightener Cutter H-348
Use in combination with poly strapping and buckles only. Fits strapping widths 3/8, 1/2 and 5/8″
INSTRUCTIONS
APPLY TENSION TO POLY STRAPPING
- Thread the poly strapping through both tightener grips and squeeze the handles to grip strapping. (See Figure 1)
- Pull the Tightener/Cutter until poly strapping is tensioned as needed. If necessary, hold down opposite side of strapping with gloved hand to prevent slipping. (See Figure 2)
TRIM EXCESS STRAPPING
- Place strapping in trimming slot. (See Figure 3)
- Squeeze handles to cut strapping.
SAFETY RULES
Read instructions carefully. Failure to follow these instructions can result in severe personal injury.
- Always wear safety glasses with side shields to prevent severe eye injury or blindness. Safety glasses should conform to ANSI Standard Z87.1 or EN 166.
- Always wear protective gloves when handling strap or sharp parts.
- Maintain proper footing and balance when operating the tool.
- DO NOT use this tool if you are not trained in its use.
- Keep work areas uncluttered and well lit.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>