BRAKE CALIPER FRONT AND BACK REPLACEMENT INSTRUCTIONS
- June 7, 2024
- Razor
Table of Contents
MX500/MX650/SX500/ RSF650/INDIAN YOUTH eFTR
BRAKE CALIPER FRONT AND BACK REPLACEMENT INSTRUCTIONS
PART# W15128190009
Required Tools: (Not included)
A. Plier
B. 5 mm Allen wrench
WARNING
CAUTION: To avoid potential shock or other injury, turn power switch OFF
and disconnect charger before performing any assembly or maintenance
procedures. Failure to follow these steps in the correct order may cause
irreparable damage.
Step 1
Using a pair of pliers, carefully pinch the silver end cap at the end of
the brake cable then remove it.
Step 2
Using a 5 mm Allen wrench, loosen the anchor bolt just enough to allow you to
pull the brake cable out from the caliper.
Step 3
Using a 5 mm Allen wrench, loosen the two hex bolts that holding the brake
caliper in place and then remove it.
Step 4
Reverse the procedures
- Replace brake caliper.
- Re-attach brake cable back into caliper and adjust accordingly.
Attention: Charge battery 12 hours before using.
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday – Friday 8:00 AM – 5:00 PM PST.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>